EUVIMEDEUVIMED entdecken
Crossref

Effects of High-Pressure Coolant Supply on Tool Wear and Axial Hole Deviation in through Hole Drilling ASTM 304 Using Twist Deep Hole Drill

Tadahiro Wada, Kazuki Hiro, Kenji Kodama, Yusuke Morigo

Key Engineering Materials · 22.06.2026 · 1058 · 163-171

DOI: 10.4028/p-lx1b9l ↗

Kurz gefasst

Fachartikel in der Zeitschrift Key Engineering Materials, online erschienen am 22.06.2026. Verfasst von Tadahiro Wada und 3 weiteren Autor:innen. Die Arbeit nennt 8 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In deep-hole drilling using long drills (L/D >= 40), chip evacuation becomes poor, and step-feed drilling is therefore employed, resulting in reduced machining efficiency. Although the use of high-pressure coolant (HPC) machining technology is expected to improve chip evacuation as well as reduce tool damage, few studies have investigated the effects of applying a high-pressure coolant to deep-hole drilling with long drills, either domestically or internationally. Therefore, this study aimed to propose and experimentally demonstrate the combined use of a high-pressure coolant during drilling in order to achieve high-efficiency and high-precision deep-hole machining (L/D = 40) using a 5-mm-diameter drill. The results that (1) at a cutting speed of 60 [m/min], the flank wear on both cutting edges was significantly greater at a coolant pressure of 0.2 [MPa] than at 20 [MPa], (2) although the axial hole deviation varied with the number of holes, it was smaller at a cutting speed of 90 [m/min] than that at 80 [m/min], and so on, were obtained.

Zitieren

APA

Wada, T., Hiro, K., Kodama, K., & Morigo, Y. (2026). Effects of High-Pressure Coolant Supply on Tool Wear and Axial Hole Deviation in through Hole Drilling ASTM 304 Using Twist Deep Hole Drill. Key Engineering Materials, 1058, 163-171. https://doi.org/10.4028/p-lx1b9l

Vancouver

Wada T, Hiro K, Kodama K, Morigo Y. Effects of High-Pressure Coolant Supply on Tool Wear and Axial Hole Deviation in through Hole Drilling ASTM 304 Using Twist Deep Hole Drill. Key Engineering Materials. 2026;1058:163-171. doi:10.4028/p-lx1b9l

BibTeX
@article{Wada2026,
  author = {Wada, Tadahiro and Hiro, Kazuki and Kodama, Kenji and Morigo, Yusuke},
  title = {Effects of High-Pressure Coolant Supply on Tool Wear and Axial Hole Deviation in through Hole Drilling ASTM 304 Using Twist Deep Hole Drill},
  journal = {Key Engineering Materials},
  year = {2026},
  volume = {1058},
  pages = {163--171},
  doi = {10.4028/p-lx1b9l}
}
Kostenlos starten →