EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Influence of the Crystal Structure of AlCrN on Tool Coating Properties and Wear in Dry Gear Hobbing

Nils Paucke, Martin Beutner, Andreas Lümkemann, Keith Thomas, Martin Učík, Hamid Bolvardi, Matthias Hackert-Oschätzchen

Defect and Diffusion Forum · 15.04.2026 · 450 · 61-70

DOI: 10.4028/p-lo2xlh ↗

Kurz gefasst

Fachartikel in der Zeitschrift Defect and Diffusion Forum, online erschienen am 15.04.2026. Verfasst von Nils Paucke und 6 weiteren Autor:innen. Die Arbeit nennt 20 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Dry machining of gears demands advanced coating technologies to withstand high thermal and mechanical stresses. In this study, AlCrN coatings were deposited using the newly developed Focused Magnetron Sputtering (FMS) process and compared with conventional Cathodic Arc Evaporation (CAE)-AlCrN and boroncontaining CAE-AlCrBN coatings. XRD analysis showed that FMS produced a finegrained crystal structure with half the full width at half maximum (FWHM) of CAE-AlCrN. Stressoptimised deposition allowed a 60 % higher coating thickness with improved adhesion. Analogy gear hobbing tests (fly cutting tests) demonstrated that FMS-AlCrN had 52 % lower crater wear than CAE-AlCrN, while CAE-AlCrBN also improved crater wear resistance due to boroninduced grain refinement. However, both finegrained coatings exhibited increased flank wear compared to the coarse-grained CAE-AlCrN coating. The results show that FMS enables the production of dense, fine-grained coatings with superior adhesion and crater wear resistance, highlighting its potential for dry gear hobbing. Further optimisation of hardness and microstructure is required to balance crater and flank wear behaviour.

Zitieren

APA

Paucke, N., Beutner, M., Lümkemann, A., Thomas, K., Učík, M., Bolvardi, H., & Hackert-Oschätzchen, M. (2026). Influence of the Crystal Structure of AlCrN on Tool Coating Properties and Wear in Dry Gear Hobbing. Defect and Diffusion Forum, 450, 61-70. https://doi.org/10.4028/p-lo2xlh

Vancouver

Paucke N, Beutner M, Lümkemann A, Thomas K, Učík M, Bolvardi H, et al. Influence of the Crystal Structure of AlCrN on Tool Coating Properties and Wear in Dry Gear Hobbing. Defect and Diffusion Forum. 2026;450:61-70. doi:10.4028/p-lo2xlh

BibTeX
@article{Paucke2026,
  author = {Paucke, Nils and Beutner, Martin and Lümkemann, Andreas and Thomas, Keith and Učík, Martin and Bolvardi, Hamid and Hackert-Oschätzchen, Matthias},
  title = {Influence of the Crystal Structure of AlCrN on Tool Coating Properties and Wear in Dry Gear Hobbing},
  journal = {Defect and Diffusion Forum},
  year = {2026},
  volume = {450},
  pages = {61--70},
  doi = {10.4028/p-lo2xlh}
}
Kostenlos starten →