EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Resistance to Fracture of Additively Manufactured Aluminium Alloy AlSi10Mg under Plane Stress Conditions

Ioannis Goulas, Alexis Kermanidis, Leonard Alberty, Ismail Ünsal, Georg Schlick, Sven Gründer, Dennis Lenhert, Florian Hengsbach, Nikolaos D. Alexopoulos

Key Engineering Materials · 13.04.2026 · 1047 · 383-389

DOI: 10.4028/p-k6i0v2 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Key Engineering Materials, online erschienen am 13.04.2026. Verfasst von Ioannis Goulas und 8 weiteren Autor:innen. Die Arbeit nennt 7 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Additive manufacturing gains ground on the production of high-precision metallic components with varying thickness. As the material thickness alters in the various locations of the product, it is eminent that the material mechanical properties might vary. In the present contribution, a preliminary study was performed to investigate the resistance to fracture of additively manufactured AlSi10Mg material with varying thicknesses. To this end, fracture toughness specimens of compact tension geometry with varying thicknesses from 3 to 15 mm were additively manufactured, machined and tested. The results showed that with increasing the specimen thickness, critical stress intensity factor K cr decreases gradually from 38 MPa√m up till 31 MPa√m for the lower and higher investigated thicknesses, respectively. Finally, it was noticed that even the 15 mm thickness (higher investigated) does not satisfy the plane strain fracture mechanism and therefore all investigated specimens were in plane-stress condition.

Zitieren

APA

Goulas, I., Kermanidis, A., Alberty, L., Ünsal, I., Schlick, G., Gründer, S., Lenhert, D., Hengsbach, F., & Alexopoulos, N. D. (2026). Resistance to Fracture of Additively Manufactured Aluminium Alloy AlSi10Mg under Plane Stress Conditions. Key Engineering Materials, 1047, 383-389. https://doi.org/10.4028/p-k6i0v2

Vancouver

Goulas I, Kermanidis A, Alberty L, Ünsal I, Schlick G, Gründer S, et al. Resistance to Fracture of Additively Manufactured Aluminium Alloy AlSi10Mg under Plane Stress Conditions. Key Engineering Materials. 2026;1047:383-389. doi:10.4028/p-k6i0v2

BibTeX
@article{Goulas2026,
  author = {Goulas, Ioannis and Kermanidis, Alexis and Alberty, Leonard and Ünsal, Ismail and Schlick, Georg and Gründer, Sven and Lenhert, Dennis and Hengsbach, Florian and Alexopoulos, Nikolaos D.},
  title = {Resistance to Fracture of Additively Manufactured Aluminium Alloy AlSi10Mg under Plane Stress Conditions},
  journal = {Key Engineering Materials},
  year = {2026},
  volume = {1047},
  pages = {383--389},
  doi = {10.4028/p-k6i0v2}
}
Kostenlos starten →