Specific Wear of Technical Shot during Shot Blasting of Free Metal Surfaces
Key Engineering Materials · 24.11.2026 · 1065 · 37-44
DOI: 10.4028/p-k5xa1m ↗Kurz gefasst
Fachartikel in der Zeitschrift Key Engineering Materials, online erschienen am 24.11.2026. Verfasst von Oleksii Goryk und 3 weiteren Autor:innen. Die Arbeit nennt 30 Literaturangaben.
Abstract (Originalsprache)
The article investigates the process of shot blasting cleaning of metal surfaces as one of the effective methods of abrasive jet processing and substantiates the use of the specific wear of technical shot as a key technical and economic indicator of the process. Specific wear is defined as the ratio of the mass of worn shot to the mass of metal removed from the surface of the workpiece over a certain operating time, which makes it possible to quantitatively assess the efficiency of abrasive material usage and the rationality of technological operating conditions. The paper presents theoretical relationships describing the wear intensity of shot, which is defined as the change in its mass over time. It has been established that the wear intensity directly depends on the mass of shot in the system and the conditions of its circulation. A model is proposed that takes into account the change in shot particle size within the parametric range and makes it possible to determine the limiting state of the shot through the diameter reduction coefficient. Based on this, expressions were obtained for calculating the lost mass of shot, the mass of worn particles, and the average mass of shot circulating in the system. The dependence of the shot mass flow rate through the nozzle on the number of its usage cycles is considered, and the mass of metal removed during the cleaning process is determined taking into account the surface productivity, the thickness of the removed layer, and the material density. Based on the substitution of the obtained relationships, a generalized formula for the specific wear of shot was derived, which takes into account the main technological parameters of the process. It is shown that reducing shot consumption and increasing cleaning productivity contribute to lowering the specific wear and improving the efficiency of the process. A practical calculation example for cleaning welded structures made of low-carbon steel is presented, confirming the possibility of applying the obtained relationships to evaluate shot consumption. Particular attention is paid to the effect of shot wear on the formation of fragments that may remain on the surface and affect the quality of protective coatings. Acceptable values for the size and concentration of such particles have been established. It is concluded that the specific wear of technical shot is an integral indicator characterizing the economic efficiency and effectiveness of shot blasting cleaning, making it possible to optimize processing conditions and predict abrasive material consumption under production conditions.
Zitieren
APA
Goryk, O., Koval'chuk, S., Brykun, O., & Riabov, A. (2026). Specific Wear of Technical Shot during Shot Blasting of Free Metal Surfaces. Key Engineering Materials, 1065, 37-44. https://doi.org/10.4028/p-k5xa1m
Vancouver
Goryk O, Koval'chuk S, Brykun O, Riabov A. Specific Wear of Technical Shot during Shot Blasting of Free Metal Surfaces. Key Engineering Materials. 2026;1065:37-44. doi:10.4028/p-k5xa1m
BibTeX
@article{Goryk2026,
author = {Goryk, Oleksii and Koval'chuk, Stanislav and Brykun, Oleksandr and Riabov, Andrii},
title = {Specific Wear of Technical Shot during Shot Blasting of Free Metal Surfaces},
journal = {Key Engineering Materials},
year = {2026},
volume = {1065},
pages = {37--44},
doi = {10.4028/p-k5xa1m}
}
EUVIMED