Using Tungsten Inert Gas Welding Equipment to Locally Heat Tubes and Achieve Inhomogeneous Thickness in Tube Sinking Processes
Key Engineering Materials · 14.04.2026 · 1048 · 83-91
DOI: 10.4028/p-jpedh0 ↗Kurz gefasst
Fachartikel in der Zeitschrift Key Engineering Materials, online erschienen am 14.04.2026. Verfasst von Lemopi Isidore Besong und 1 weiteren Autor:innen. Die Arbeit nennt 11 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Tubes with non-uniform thickness are needed to even out wall thickness in draw bending and provide higher stiffness in specific directions in some applications. Tailored local heating of the tubes in tube sinking operations should reduce the local flow stresses and facilitate differential deformation along the circumference of tubes to form tubes with uneven wall thicknesses. Local heating of tubes prior to entry into the die in tube sinking is implemented in this research to form tubes with higher thickness in desired directions. Initial experiments are conducted using plasma heating by tungsten inert gas (TIG) welding equipment on EN AW 6060 AlMgSi0.5 aluminum tubes. The process window is described by varying the process temperature (weld current between 50 A and 80 A) while altering the degree of deformation, the tube diameter, and tube thickness. Tubes with no defects were formed at 50 A. Increasing the weld current led to a higher wall thickness (up to 25% thickness increase), however, high weld currents also favored the formation of surface defects, wrinkle formation, or burn-through holes depending on the process setup. The process window was larger for tubes with higher wall thickness.
Zitieren
APA
Besong, L. I., & Buhl, J. (2026). Using Tungsten Inert Gas Welding Equipment to Locally Heat Tubes and Achieve Inhomogeneous Thickness in Tube Sinking Processes. Key Engineering Materials, 1048, 83-91. https://doi.org/10.4028/p-jpedh0
Vancouver
Besong LI, Buhl J. Using Tungsten Inert Gas Welding Equipment to Locally Heat Tubes and Achieve Inhomogeneous Thickness in Tube Sinking Processes. Key Engineering Materials. 2026;1048:83-91. doi:10.4028/p-jpedh0
BibTeX
@article{Besong2026,
author = {Besong, Lemopi Isidore and Buhl, Johannes},
title = {Using Tungsten Inert Gas Welding Equipment to Locally Heat Tubes and Achieve Inhomogeneous Thickness in Tube Sinking Processes},
journal = {Key Engineering Materials},
year = {2026},
volume = {1048},
pages = {83--91},
doi = {10.4028/p-jpedh0}
}
EUVIMED