EUVIMEDEUVIMED entdecken
Crossref

Flow Stoppage in the Middle Area of Flow Length Occurs at Thin Die Gap

Toshio Haga, Hirofumi Sakaue, Hiroshi Fuse, Hisaki Watari

Advanced Engineering Forum · 24.06.2026 · 59 · 1-7

DOI: 10.4028/p-iw2siu ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advanced Engineering Forum, online erschienen am 24.06.2026. Verfasst von Toshio Haga und 3 weiteren Autor:innen. Die Arbeit nennt 7 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In molten metal flow length tests using a spiral die with a thin gap, a non-filled region of molten metal was observed in the middle of the flow length in some test pieces. The influences of die gap, plunger speed and die temperature on the position and length of the non-filled region were investigated. Both the die gap and molten metal speed significantly affected the occurrence, position and length of non-filled region. The phenomenon of molten metal flow stoppage in the middle of flow length is discussed based on the non-filled regions in the test pieces.

Zitieren

APA

Haga, T., Sakaue, H., Fuse, H., & Watari, H. (2026). Flow Stoppage in the Middle Area of Flow Length Occurs at Thin Die Gap. Advanced Engineering Forum, 59, 1-7. https://doi.org/10.4028/p-iw2siu

Vancouver

Haga T, Sakaue H, Fuse H, Watari H. Flow Stoppage in the Middle Area of Flow Length Occurs at Thin Die Gap. Advanced Engineering Forum. 2026;59:1-7. doi:10.4028/p-iw2siu

BibTeX
@article{Haga2026,
  author = {Haga, Toshio and Sakaue, Hirofumi and Fuse, Hiroshi and Watari, Hisaki},
  title = {Flow Stoppage in the Middle Area of Flow Length Occurs at Thin Die Gap},
  journal = {Advanced Engineering Forum},
  year = {2026},
  volume = {59},
  pages = {1--7},
  doi = {10.4028/p-iw2siu}
}
Kostenlos starten →