EUVIMEDEUVIMED entdecken
Crossref

Parameter Design of Sand Casting to Minimize Shrinkage Defects, Porosity Defects and Incomplete Defects

Syah Rizal Muzaqqi, Suprayitno Suprayitno, Yanuar Rohmat Aji Pradana

Materials Science Forum · 21.05.2024 · 1122 · 3-9

DOI: 10.4028/p-ck89wq ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials Science Forum, online erschienen am 21.05.2024. Verfasst von Syah Rizal Muzaqqi und 2 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 8 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Casting is one of the most commonly used manufacturing method for geometrically complex product. Among the casting technologies, sand casting is often found in application. Beside the advantages of the sand-casting process, it also has a drawback that is often encountered, namely product defects. Product defects can be caused by a lack of attention to sand casting parameters. This work aims to minimize those defects, including porosity defects, shrinkage defects and incomplete defects by optimizing process parameters using the Taguchi method. The identified sand-casting process parameters include gating location, riser location, molding conditions and pouring temperature with each parameter consisting of 3 levels. This research using the fractional factorial L 9 (3 4 ). Data processing is carried out by analysis of mean (ANOM) to obtain plot effects. The results showed that the optimal combination of parameters that resulted in shrinkage, porosity and minimal incomplete defects were at gating location level 2, riser location level 1, mold condition level 2 and pouring temperature level 3. The results of the comparison before and after optimization were an increase of 0.77, where previously it was 1.30 to 2.07 based on normalized data.

Zitieren

APA

Muzaqqi, S. R., Suprayitno, S., & Pradana, Y. R. A. (2024). Parameter Design of Sand Casting to Minimize Shrinkage Defects, Porosity Defects and Incomplete Defects. Materials Science Forum, 1122, 3-9. https://doi.org/10.4028/p-ck89wq

Vancouver

Muzaqqi SR, Suprayitno S, Pradana YRA. Parameter Design of Sand Casting to Minimize Shrinkage Defects, Porosity Defects and Incomplete Defects. Materials Science Forum. 2024;1122:3-9. doi:10.4028/p-ck89wq

BibTeX
@article{Muzaqqi2024,
  author = {Muzaqqi, Syah Rizal and Suprayitno, Suprayitno and Pradana, Yanuar Rohmat Aji},
  title = {Parameter Design of Sand Casting to Minimize Shrinkage Defects, Porosity Defects and Incomplete Defects},
  journal = {Materials Science Forum},
  year = {2024},
  volume = {1122},
  pages = {3--9},
  doi = {10.4028/p-ck89wq}
}
Kostenlos starten →