Feasibility of Direct 3D Printing Foam Polylactic Acid with MEX
Key Engineering Materials · 13.04.2026 · 1047 · 223-230
DOI: 10.4028/p-3aele3 ↗Kurz gefasst
Fachartikel in der Zeitschrift Key Engineering Materials, online erschienen am 13.04.2026. Verfasst von Batagiannis Athanasios und 4 weiteren Autor:innen. Die Arbeit nennt 12 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Additive manufacturing of polymeric foams via Material Extrusion (MEX) is an attractive route to lightweight components with tunable mechanical response. However, reproducible performance remains challenging because foam expansion, cell stabilization, and inter-layer bonding are strongly governed by the thermal–processing window. This study evaluates the feasibility of directly printing a commercial PLA foaming filament and quantifies the influence of nozzle temperature (and the associated flow-rate adjustment) on density and tensile behavior. ISO 527-2 tensile specimens were printed under three printing-condition combinations, a nominal PLA setting (190°C, 100% flow) and two foaming-window settings (250°C, 55% flow and 270°C, 50% flow). Tensile tests were conducted, and the tensile properties were assessed via Young’s Modulus, Yield and Ultimate properties (stress/strain), and elastic and total absorbed energy up to fracture. In addition to absolute values, all relevant metrics were normalized by relative density to enable robust comparisons across foaming levels. Finally, the DIC maps at the Yield and Fracture point were used to support the derived results and conclusions.
Zitieren
APA
Athanasios, B., Karmiris-Obratański, P., Christodoulou, I. T., Papazoglou, E. L., & Markopoulos, A. P. (2026). Feasibility of Direct 3D Printing Foam Polylactic Acid with MEX. Key Engineering Materials, 1047, 223-230. https://doi.org/10.4028/p-3aele3
Vancouver
Athanasios B, Karmiris-Obratański P, Christodoulou IT, Papazoglou EL, Markopoulos AP. Feasibility of Direct 3D Printing Foam Polylactic Acid with MEX. Key Engineering Materials. 2026;1047:223-230. doi:10.4028/p-3aele3
BibTeX
@article{Athanasios2026,
author = {Athanasios, Batagiannis and Karmiris-Obratański, Panagiotis and Christodoulou, Ioannis T. and Papazoglou, Emmanouil Lazaros and Markopoulos, Angelos P.},
title = {Feasibility of Direct 3D Printing Foam Polylactic Acid with MEX},
journal = {Key Engineering Materials},
year = {2026},
volume = {1047},
pages = {223--230},
doi = {10.4028/p-3aele3}
}
EUVIMED