EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Static Finite Element Modeling of Milling in Flexible Composite Plates

Matthias Nutte, Edouard Rivière-Lorphèvre, Valentin Dambly, Pedro José Arrazola, Ismail Lazoglu, Aurélie Granjon, François Ducobu

Defect and Diffusion Forum · 15.04.2026 · 450 · 93-102

DOI: 10.4028/p-2lx7wd ↗

Kurz gefasst

Fachartikel in der Zeitschrift Defect and Diffusion Forum, online erschienen am 15.04.2026. Verfasst von Matthias Nutte und 6 weiteren Autor:innen. Die Arbeit nennt 15 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study presents a static finite element analysis of the milling of a flexible unidirectional glass fiber–reinforced polymer (UD-GFRP) plate. The workpiece is modeled as a clamped–free cantilever, with cutting forces evaluated independently of structural deflections and applied along the machined edge. SC8R continuum shell elements are employed to accurately represent through-thickness loading and bending behavior. A mesh sensitivity analysis is conducted to determine a suitable discretization, leading to a 64 × 56 × 8 element mesh. For the investigated configuration (, mm/tooth), the out-of-plane displacement reaches approximately 120 µm near the free end of the plate, whereas in-plane displacements reach up to-75 µm. These in-plane displacements are greater than or equal to the nominal feed per tooth, indicating a highly significant influence on chip formation. This work provides a basis for understanding the structural response of flexible composite plates during trimming and emphasizes the need for coupled force–deformation formulations.

Zitieren

APA

Nutte, M., Rivière-Lorphèvre, E., Dambly, V., Arrazola, P. J., Lazoglu, I., Granjon, A., & Ducobu, F. (2026). Static Finite Element Modeling of Milling in Flexible Composite Plates. Defect and Diffusion Forum, 450, 93-102. https://doi.org/10.4028/p-2lx7wd

Vancouver

Nutte M, Rivière-Lorphèvre E, Dambly V, Arrazola PJ, Lazoglu I, Granjon A, et al. Static Finite Element Modeling of Milling in Flexible Composite Plates. Defect and Diffusion Forum. 2026;450:93-102. doi:10.4028/p-2lx7wd

BibTeX
@article{Nutte2026,
  author = {Nutte, Matthias and Rivière-Lorphèvre, Edouard and Dambly, Valentin and Arrazola, Pedro José and Lazoglu, Ismail and Granjon, Aurélie and Ducobu, François},
  title = {Static Finite Element Modeling of Milling in Flexible Composite Plates},
  journal = {Defect and Diffusion Forum},
  year = {2026},
  volume = {450},
  pages = {93--102},
  doi = {10.4028/p-2lx7wd}
}
Kostenlos starten →