EUVIMEDEUVIMED entdecken
Crossref

Optimizing the Performance of Plastic Injection Molding Using Weighted Additive Model in Goal Programming

Abbas Al-Refaie, Ming-Hsien Li

International Journal of Fuzzy System Applications · 2011

DOI: 10.4018/ijfsa.2011040104 ↗

Kurz gefasst

Fachartikel in der Zeitschrift International Journal of Fuzzy System Applications, 2011. Verfasst von Abbas Al-Refaie und 1 weiteren Autor:innen. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 12 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Injection molding process is increasingly more significant in today’s plastic production industries because it provides high-quality product, short product cycles, and light weight. This research optimizes the performance of this process with three main quality responses: defect count, cycle time, and spoon weight, using the weighted additive goal programming model. The three quality responses and process factors are described by appropriate membership functions. The Taguchi’s orthogonal array is then utilized to provide experimental layout. A linear optimization based on the weighted additive model in goal programming model is built to minimize the deviations of the product/process targets from their corresponding imprecise fuzzy values specified by the process engineer’s preferences. The results show that the average defect count is reduced from an average of 0.75 to 0.16. Moreover, the average cycle time becomes 13.06 seconds, which is significantly smaller than that obtained at initial factor settings (= 15.10 seconds). Finally, the average spoon weight is exactly on its target value of 2.0 gm.

Zitieren

APA

Al-Refaie, A., & Li, M. (2011). Optimizing the Performance of Plastic Injection Molding Using Weighted Additive Model in Goal Programming. International Journal of Fuzzy System Applications. https://doi.org/10.4018/ijfsa.2011040104

Vancouver

Al-Refaie A, Li M. Optimizing the Performance of Plastic Injection Molding Using Weighted Additive Model in Goal Programming. International Journal of Fuzzy System Applications. 2011. doi:10.4018/ijfsa.2011040104

BibTeX
@article{AlRefaie2011,
  author = {Al-Refaie, Abbas and Li, Ming-Hsien},
  title = {Optimizing the Performance of Plastic Injection Molding Using Weighted Additive Model in Goal Programming},
  journal = {International Journal of Fuzzy System Applications},
  year = {2011},
  doi = {10.4018/ijfsa.2011040104}
}
Kostenlos starten →