Fabrication of multi-mode tip fiber sensor based on surface plasmon resonance (SPR)
Sustainable Engineering and Innovation · 2020
DOI: 10.37868/sei.v2i1.27 ↗Kurz gefasst
Fachartikel in der Zeitschrift Sustainable Engineering and Innovation, 2020. Verfasst von Nidaa AL-Janaby und 1 weiteren Autor:innen. Die Arbeit wurde bisher 16-mal zitiert (Crossref). Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
In this research, a fiber optic sensor based on surface plasmon resonance (SPR) was prepared. The sensor of SPR was configured using a gold thin layer at the end of a cleaved optical fiber by a sputtering technique. The source of white light was utilized to produce a series of wavelengths and excites surface plasmon resonance at the fiber tip. The SPR sensor was immersed into media with different refractive indices in the range of 1 to 1.58, including their similar plasmon resonance wavelength shifts that were saved by the optical spectrum analyzer. Experimental results that were obtained show there is a redshift when increasing the refractive index of solutions and sensitivity reach 298nm/ RIU, and resolution 4.31x?10?^(-4).
Zitieren
APA
AL-Janaby, N., & AL-Dergazly, A. (2020). Fabrication of multi-mode tip fiber sensor based on surface plasmon resonance (SPR). Sustainable Engineering and Innovation. https://doi.org/10.37868/sei.v2i1.27
Vancouver
AL-Janaby N, AL-Dergazly A. Fabrication of multi-mode tip fiber sensor based on surface plasmon resonance (SPR). Sustainable Engineering and Innovation. 2020. doi:10.37868/sei.v2i1.27
BibTeX
@article{ALJanaby2020,
author = {AL-Janaby, Nidaa and AL-Dergazly, Anwaar},
title = {Fabrication of multi-mode tip fiber sensor based on surface plasmon resonance (SPR)},
journal = {Sustainable Engineering and Innovation},
year = {2020},
doi = {10.37868/sei.v2i1.27}
}
EUVIMED