Cracking mechanism in single-pass molten pool of laser-directed energy deposition-manufactured FeCoCrNiAl high-entropy alloy coatings
Materials Science in Additive Manufacturing · 06.08.2026 · 026240056
DOI: 10.36922/msam026240056 ↗Kurz gefasst
Fachartikel in der Zeitschrift Materials Science in Additive Manufacturing, online erschienen am 06.08.2026. Verfasst von Guang Zeng und 3 weiteren Autor:innen.
Abstract (Originalsprache)
To meet the critical strategic demands of deep-sea and polar exploration, there is an urgent need to develop a new generation of marine exploration equipment with enhanced corrosion resistance, drag reduction, and ice prevention capabilities. High-entropy alloy (HEA) coatings are an effective way to address these problems, offering excellent corrosion resistance, high mechanical properties, and drag-reduction characteristics. Laser-directed energy deposition (LDED) additive manufacturing is an advanced manufacturing technique for fabricating HEA coatings, enabling the deposition of components on complex curved surfaces while delivering excellent overall performance. However, the inherent cracking problem in LDED-processed HEAs accelerates rapid damage and coating failure. In this work, the FeCoCrNiAl HEA coatings were fabricated on the GCr18Mo substrate using LDED. The crack types and underlying cracking mechanisms, as well as crack-induced hardness degradation mechanisms, are elucidated. The results show that the defect types include solidification cracks, heat-affected zone (HAZ) cracks, and gas pores, with solidification cracks accounting for a substantial proportion. The hot stress in the molten pool exceeds the coating strength. The residual tensile stress (~ 900 MPa) in the HAZ exceeds the yield strength of the matrix, while stress fluctuations in the molten pool during solidification triggered crack initiation. The cracking mechanism is closely related to grain orientation, dislocation accumulation, and carbide. The geometrically necessary dislocation density at the crack (~ 1.33 × 1014 m−2) is higher than that in the matrix. Hard carbide particles play a critical role in crack initiation. Moreover, solidification cracks are a mixture of trans-granular and inter-granular cracks. The hardness of the molten pool, HAZ, and interface zones is higher than that of the substrate, with the HAZ exhibiting a hardness 3.53 times higher. Cracks cause a localized reduction in hardness, with the most pronounced decrease occurring in the solidification crack region. Clarifying the cracking mechanism of the LDED-manufactured HEA coatings will contribute to breakthroughs in marine engineering equipment.
Zitieren
APA
Zeng, G., Hu, X., Liu, W., & Sun, K. (2026). Cracking mechanism in single-pass molten pool of laser-directed energy deposition-manufactured FeCoCrNiAl high-entropy alloy coatings. Materials Science in Additive Manufacturing, 0(0), 026240056. https://doi.org/10.36922/msam026240056
Vancouver
Zeng G, Hu X, Liu W, Sun K. Cracking mechanism in single-pass molten pool of laser-directed energy deposition-manufactured FeCoCrNiAl high-entropy alloy coatings. Materials Science in Additive Manufacturing. 2026;0(0):026240056. doi:10.36922/msam026240056
BibTeX
@article{Zeng2026,
author = {Zeng, Guang and Hu, Xinyu and Liu, Wenjie and Sun, Ke},
title = {Cracking mechanism in single-pass molten pool of laser-directed energy deposition-manufactured FeCoCrNiAl high-entropy alloy coatings},
journal = {Materials Science in Additive Manufacturing},
year = {2026},
volume = {0},
number = {0},
pages = {026240056},
doi = {10.36922/msam026240056}
}
EUVIMED