EUVIMEDEUVIMED entdecken
Crossref

Gas versus plasma atomized powder in laser powder bed fusion of Grade 5 Ti6Al4V: Processing characteristics and mechanical properties

Jordan Hatch, Alex Hicker, Chris Liu, Alex Montelione, Reid Schur, Cory Cunningham, Mamidala Ramulu, Dwayne D. Arola

Materials Science in Additive Manufacturing · 15.06.2026 · 5 (3) · 026030001

DOI: 10.36922/msam026030001 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials Science in Additive Manufacturing, online erschienen am 15.06.2026. Verfasst von Jordan Hatch und 7 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Additive manufacturing (AM) of metal components by laser powder bed fusion (L-PBF) has become a viable method of manufacturing in various industries. However, new challenges are emerging, including the high cost of powder feedstock and concerns associated with its reuse. Here, L-PBF was performed with two commercial sources of Grade 5 Ti6Al4V, including commercial plasma-atomized (PA) and gas-atomized (GA) powders. The overall objective was to evaluate differences in the quality, spatial variations in mechanical properties of metal produced with the PA and GA powders over a series of six builds, and to assess if GA powder could be used to replace PA powder for cost savings. The mechanical properties were characterized in uniaxial tension considering powder type, reuse and location within the build envelope. Results showed that the yield and ultimate tensile strength of metal produced with GA powder were significantly lower than that produced with PA powder (p ≤ 0.05). In addition, spatial variation in the mechanical properties was greatest for the GA powder. The lower strength and greater spatial variation in printing with GA powder appears related to the larger quantity of fines and powder particle satellites, which promote porosity. Overall, the findings indicate that components built with GA powder would: (i) require separate optimization of the printing parameters relative to those used for PA powder, and/or (ii) require additional post-processing to achieve the same performance as those built with PA powder.

Zitieren

APA

Hatch, J., Hicker, A., Liu, C., Montelione, A., Schur, R., Cunningham, C., Ramulu, M., & Arola, D. D. (2026). Gas versus plasma atomized powder in laser powder bed fusion of Grade 5 Ti6Al4V: Processing characteristics and mechanical properties. Materials Science in Additive Manufacturing, 5(3), 026030001. https://doi.org/10.36922/msam026030001

Vancouver

Hatch J, Hicker A, Liu C, Montelione A, Schur R, Cunningham C, et al. Gas versus plasma atomized powder in laser powder bed fusion of Grade 5 Ti6Al4V: Processing characteristics and mechanical properties. Materials Science in Additive Manufacturing. 2026;5(3):026030001. doi:10.36922/msam026030001

BibTeX
@article{Hatch2026,
  author = {Hatch, Jordan and Hicker, Alex and Liu, Chris and Montelione, Alex and Schur, Reid and Cunningham, Cory and Ramulu, Mamidala and Arola, Dwayne D.},
  title = {Gas versus plasma atomized powder in laser powder bed fusion of Grade 5 Ti6Al4V: Processing characteristics and mechanical properties},
  journal = {Materials Science in Additive Manufacturing},
  year = {2026},
  volume = {5},
  number = {3},
  pages = {026030001},
  doi = {10.36922/msam026030001}
}
Kostenlos starten →