EUVIMEDEUVIMED entdecken
Crossref

Shape morphing of extrusion-printed thermoresponsive hydrogels regulated by infill topology and layer design

Xi Yin, Shishuo Liu, Yanglong Lu

Engineering Science in Additive Manufacturing · 12.06.2026 · 2 (2) · 026180008

DOI: 10.36922/esam026180008 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Engineering Science in Additive Manufacturing, online erschienen am 12.06.2026. Verfasst von Xi Yin und 2 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Four-dimensional (4D) printing offers an innovative method for fabricating thermoresponsive hydrogel structures with programmable shape changes. Although structural regulation has been explored in some stimuli-responsive shape-morphing materials, the influence of infill topology on thermally induced deformation in extrusion-printed thermoresponsive hydrogels remains insufficiently clarified. As a programmable structural feature in extrusion-based printing, infill topology can provide a practical route for regulating thermally induced deformation while retaining the potential advantages of infill-based lightweight design. In this study, a poly(N-isopropylacrylamide) (PNIPAM)-based thermoresponsive hydrogel ink was used as active ink, while alginate/laponite-based hydrogel ink was used as the passive constraining ink. These inks were used to fabricate hydrogel structures with different internal architectures, and their temperature-dependent deformation behaviors were systematically compared. Structures printed entirely from the active ink showed no obvious macroscopic bending during heating, although both cell area and overall shape area decreased with temperature. This suggests that the response of structures with only the active material was mainly dominated by thermal deswelling. In contrast, structures with an active–passive architecture exhibited clear temperature-dependent bending, showing that the active–passive mismatch was essential for converting material response into macroscopic shape change. Within this system, infill topology strongly affected bending level, with rectilinear patterns producing the strongest response and grid patterns the weakest. Under a fixed honeycomb topology, increasing active-layer infill density further enhanced bending. In addition, a heterogeneous active-layer design that combined two topologies in a single structure preserved local deformation differences, while the final bending response was governed by mechanical coupling throughout the structure. Overall, these results show that active–passive layer architecture, infill topology, and layer-specific infill design can regulate thermally induced shape morphing in printed hydrogel systems. This study guides the design of thermoresponsive hydrogel structures for soft actuation and related programmable devices.

Zitieren

APA

Yin, X., Liu, S., & Lu, Y. (2026). Shape morphing of extrusion-printed thermoresponsive hydrogels regulated by infill topology and layer design. Engineering Science in Additive Manufacturing, 2(2), 026180008. https://doi.org/10.36922/esam026180008

Vancouver

Yin X, Liu S, Lu Y. Shape morphing of extrusion-printed thermoresponsive hydrogels regulated by infill topology and layer design. Engineering Science in Additive Manufacturing. 2026;2(2):026180008. doi:10.36922/esam026180008

BibTeX
@article{Yin2026,
  author = {Yin, Xi and Liu, Shishuo and Lu, Yanglong},
  title = {Shape morphing of extrusion-printed thermoresponsive hydrogels regulated by infill topology and layer design},
  journal = {Engineering Science in Additive Manufacturing},
  year = {2026},
  volume = {2},
  number = {2},
  pages = {026180008},
  doi = {10.36922/esam026180008}
}
Kostenlos starten →