EUVIMEDEUVIMED entdecken
Open Access

Understanding the reusability of Ti6Al4V powder in laser powder bed fusion

Nathaniel W Zuckschwerdt, Amit Bandyopadhyay

Engineering Science in Additive Manufacturing · 2025

DOI: 10.36922/esam025420028 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Engineering Science in Additive Manufacturing, 2025. Verfasst von Nathaniel W Zuckschwerdt und 1 weiteren Autor:innen. Beteiligte Einrichtung: W. M. Keck Biomedical Materials Research Lab, School of Mechanical and Materials Engineering, Washington State University, Pullman, Washington, 99146…. Die Arbeit wurde bisher 1-mal zitiert (Crossref). Der Volltext ist frei in PubMed Central verfügbar. Gefördert von: NIAMS NIH HHS.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study aimed to determine the effects of how powder degrades in quality from use in the laser powder bed fusion process and investigate what changes in the powder cause defects in finished parts. It was determined that the reused powder affected the finished part quality, resulting in an increased number of lack-of-fusion pores. This was due to a change in the size distribution of the powder particles, characterized by an increase in larger sizes and a significant decrease in smaller sizes. There was an 11% increase in defective particles over the five prints that went through the sieving process, as well as an increase of ~2% of particles >63 μm, resulting in less powder that could be reused after each print. The results enabled the determination of the life of the powder due to the degradation of the powder from the differing property changes caused by the reuse of the powder.

Schlagwörter

Stichwörter der Autor:innen

3D PrintingAdditive manufacturingLPBFPowder degradationTi6Al4V

Autor:innen und Institutionen

  • W. M. Keck Biomedical Materials Research Lab, School of Mechanical and Materials Engineering, Washington State University, Pullman, Washington, 99146-2920, USA.

Förderung

  • NIAMS NIH HHS

Zitieren

APA

Zuckschwerdt, N. W., & Bandyopadhyay, A. (2025). Understanding the reusability of Ti6Al4V powder in laser powder bed fusion. Engineering Science in Additive Manufacturing. https://doi.org/10.36922/esam025420028

Vancouver

Zuckschwerdt NW, Bandyopadhyay A. Understanding the reusability of Ti6Al4V powder in laser powder bed fusion. Engineering Science in Additive Manufacturing. 2025. doi:10.36922/esam025420028

BibTeX
@article{Zuckschwerdt2025,
  author = {Zuckschwerdt, Nathaniel W and Bandyopadhyay, Amit},
  title = {Understanding the reusability of Ti6Al4V powder in laser powder bed fusion},
  journal = {Engineering Science in Additive Manufacturing},
  year = {2025},
  doi = {10.36922/esam025420028}
}
Kostenlos starten →