EUVIMEDEUVIMED entdecken
Crossref

Impact of machine factors on the surface quality of parts fabricated via powder bed fusion

Zhen Lu, Ming Jen Tan, Yi Zhang, Jia An, Chee Kai Chua

Engineering Science in Additive Manufacturing · 2025

DOI: 10.36922/esam025240014 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Engineering Science in Additive Manufacturing, 2025. Verfasst von Zhen Lu und 4 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In the growing additive manufacturing industry, there is increasing demand for improved as-built surface quality of parts fabricated by the powder bed fusion (PBF) process, particularly in the aerospace, medical, and tooling industrial sectors. The surface finish of PBF parts is often suboptimal due to the inherent layer-by-layer fabrication process. Depending on the material used, the average surface roughness (Ra) of PBF components typically ranges from 5 to 50 μm. To address this issue, various strategies have been investigated, including optimizing printing process parameters, refining support designs, and upgrading laser hardware. In this study, we investigated the machine factors on the as-built surface quality of parts in the PBF process. Fully dense as-built 1.2709 tool steel parts were produced with a relative density of 99.9% using platform pre-heating. Without heat treatment, the as-built part exhibited an ultimate tensile strength of 1,135 ± 75 MPa, yield strength of 915 ± 120 MPa, and an elongation of 12 ± 3%. Vickers hardness was measured at 339 ± 35. Surface measurements were performed on parts placed across the substrate plate, with the Ra of as-built vertical walls averaging 22.6 ± 11.9 mm. Results showed that the surface quality of as-built 1.2709 tool steel parts, with a layer thickness of 30 μm, was significantly affected by their distance from the inert gas outlet and the laser center. This study demonstrates that the as-built surface quality of PBF parts can be controlled through more effective build job preparation without changing key processing parameters.

Zitieren

APA

Lu, Z., Tan, M. J., Zhang, Y., An, J., & Chua, C. K. (2025). Impact of machine factors on the surface quality of parts fabricated via powder bed fusion. Engineering Science in Additive Manufacturing. https://doi.org/10.36922/esam025240014

Vancouver

Lu Z, Tan MJ, Zhang Y, An J, Chua CK. Impact of machine factors on the surface quality of parts fabricated via powder bed fusion. Engineering Science in Additive Manufacturing. 2025. doi:10.36922/esam025240014

BibTeX
@article{Lu2025,
  author = {Lu, Zhen and Tan, Ming Jen and Zhang, Yi and An, Jia and Chua, Chee Kai},
  title = {Impact of machine factors on the surface quality of parts fabricated via powder bed fusion},
  journal = {Engineering Science in Additive Manufacturing},
  year = {2025},
  doi = {10.36922/esam025240014}
}
Kostenlos starten →