EUVIMEDEUVIMED entdecken
Crossref

Contamination of the zirconia surface by components of mixed saliva and its control by X-ray photoelectron spectroscopy. Part 2. Influence of the functional monomer MDP-10

R. A. Meremkulov, Z. S. Khabadze, E. M. Kakabadze, D. F. Rasulova, A. Yu. Umarov, A. R. Rumiantseva, A. O. Murtazaliev, A. S. Trofimova

Endodontics Today · 24.09.2026

DOI: 10.36377/et-0238 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Endodontics Today, online erschienen am 24.09.2026. Verfasst von R. A. Meremkulov und 7 weiteren Autor:innen. Die Arbeit nennt 14 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

INTRODUCTION. The strength of adhesive luting of zirconia restorations largely depends on the surface state. Primers based on the functional monomer 10-methacryloyloxydecyl dihydrogen phosphate (MDP-10) provide chemical bonding of the adhesive to the oxide surface; however, during try-in the framework contacts mixed saliva, whose organic components may adsorb onto the surface. The effect of prior MDP-10 application on such contamination and its subsequent removability is insufficiently studied. PURPOSE. To study the influence of the functional monomer MDP-10 on the elemental composition of the zirconia surface and on the resistance of the MDP-10-primed surface to salivary mucin contamination using X-ray photoelectron spectroscopy (XPS). MATERIALS AND METHODS. Yttria-stabilized zirconia (Y-TZP) plates were examined in three states: after application of an MDP-10 solution in isopropanol (MDP-10); after subsequent application of a mucin model (MDP-10 + mucin); and after mucin application followed by distilled-water rinsing (MDP-10 + mucin + rinsing). Atomic concentrations of C, N, O, and P were determined by XPS (PREVAC EA15, Al Kα, hν = 1486.6 eV) and the P/N ratio was calculated ( n = 6 per group). Data were analysed by one-way ANOVA with Tukey post-hoc test. RESULTS. The MDP-10-primed surface showed a pronounced phosphorus signal (P = 7.24 ± 0.12 at.%) with low nitrogen content (N = 1.10 ± 0.05 at.%; P/N = 6.59 ± 0.36). Mucin application increased nitrogen to 2.42 ± 0.05 at.% and reduced P/N to 2.96 ± 0.08 ( p < 0.001). After rinsing, nitrogen returned to the level of the MDP-10-primed surface (1.12 ± 0.05 at.%; no difference from the MDP-10 group, p = 0.77), and P/N largely recovered (5.84 ± 0.34). The phosphorus signal persisted in all groups. CONCLUSION. MDP-10 forms a stable phosphate-containing layer on the zirconia surface. Salivary mucin adsorbs on top of the MDP-10 layer but, unlike on the untreated surface, is effectively removed by water rinsing, with nitrogen returning to baseline. MDP-10 priming increases the resistance of the surface to irreversible organic contamination, which is relevant to the protocol of preparing restorations for luting.

Zitieren

APA

Meremkulov, R. A., Khabadze, Z. S., Kakabadze, E. M., Rasulova, D. F., Umarov, A. Y., Rumiantseva, A. R., Murtazaliev, A. O., & Trofimova, A. S. (2026). Contamination of the zirconia surface by components of mixed saliva and its control by X-ray photoelectron spectroscopy. Part 2. Influence of the functional monomer MDP-10. Endodontics Today. https://doi.org/10.36377/et-0238

Vancouver

Meremkulov RA, Khabadze ZS, Kakabadze EM, Rasulova DF, Umarov AY, Rumiantseva AR, et al. Contamination of the zirconia surface by components of mixed saliva and its control by X-ray photoelectron spectroscopy. Part 2. Influence of the functional monomer MDP-10. Endodontics Today. 2026. doi:10.36377/et-0238

BibTeX
@article{Meremkulov2026,
  author = {Meremkulov, R. A. and Khabadze, Z. S. and Kakabadze, E. M. and Rasulova, D. F. and Umarov, A. Yu. and Rumiantseva, A. R. and Murtazaliev, A. O. and Trofimova, A. S.},
  title = {Contamination of the zirconia surface by components of mixed saliva and its control by X-ray photoelectron spectroscopy. Part 2. Influence of the functional monomer MDP-10},
  journal = {Endodontics Today},
  year = {2026},
  doi = {10.36377/et-0238}
}
Kostenlos starten →