EUVIMEDEUVIMED entdecken
Crossref

Simulating the effect of depth of cut and feed rate on the force components in face milling

Mohammad Zaher Akkad, Felhő Csaba

Multidiszciplináris Tudományok · 2019

DOI: 10.35925/j.multi.2019.1.9 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Multidiszciplináris Tudományok, 2019. Verfasst von Mohammad Zaher Akkad und 1 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper presents a study about the workpiece force components (Fx, Fy, Fz) changes in face milling, which results from changing the depth of cut and the feed rate values. The values of the three force components in the face milling operation were found through the FEA-software AdvantEdge by Third Wave Systems. This program is uniquely intended for modelling of cutting processes. Simulations were carried out within five different cutting depth of cut and feed rate, to compare the obtained values and find out the results of the impact of changes on the three force components.

Zitieren

APA

Akkad, M. Z., & Csaba, F. (2019). Simulating the effect of depth of cut and feed rate on the force components in face milling. Multidiszciplináris Tudományok. https://doi.org/10.35925/j.multi.2019.1.9

Vancouver

Akkad MZ, Csaba F. Simulating the effect of depth of cut and feed rate on the force components in face milling. Multidiszciplináris Tudományok. 2019. doi:10.35925/j.multi.2019.1.9

BibTeX
@article{Akkad2019,
  author = {Akkad, Mohammad Zaher and Csaba, Felhő},
  title = {Simulating the effect of depth of cut and feed rate on the force components in face milling},
  journal = {Multidiszciplináris Tudományok},
  year = {2019},
  doi = {10.35925/j.multi.2019.1.9}
}
Kostenlos starten →