Analysis of Hydrotest Failure Risk on Line Pipe System Using Failure Mode and Effects Analysis (FMEA) Method
JKIE (Journal Knowledge Industrial Engineering) · 31.08.2026 · 12 (2) · 208-223
DOI: 10.35891/cb0dn991 ↗Kurz gefasst
Fachartikel in der Zeitschrift JKIE (Journal Knowledge Industrial Engineering), online erschienen am 31.08.2026. Verfasst von Yruan Lumbangaol und 1 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-SA 4.0).
Abstract (Originalsprache)
The hydrotest process in a line pipe system is an essential stage to verify piping strength, integrity, and leak tightness before operation in the oil and gas industry. However, potential failures during hydrotest may cause leakage, structural damage, delays, rework, and safety risks. This study aims to identify failure modes, analyze risk priorities, and propose improvement strategies using the Failure Mode and Effects Analysis (FMEA) method. Risk evaluation was based on Severity (S), Occurrence (O), and Detection (D) parameters. Data were collected through observations, interviews, and failure documentation from August to December 2025. The results identified four main failure modes: flange/gasket leakage, weld joint failure, overpressure, and internal corrosion. Weld joint failure obtained the highest Risk Priority Number (RPN) value of 270, followed by flange/gasket leakage and overpressure with RPN values of 240, and internal corrosion with an RPN value of 180. Improvement actions include welding quality enhancement, NDT inspection, installation control, instrument calibration, pressure monitoring, and pipe drying optimization. The findings support efforts to improve hydrotest reliability and reduce piping system risks.
Zitieren
APA
Lumbangaol, Y., & Irwan, H. (2026). Analysis of Hydrotest Failure Risk on Line Pipe System Using Failure Mode and Effects Analysis (FMEA) Method. JKIE (Journal Knowledge Industrial Engineering), 12(2), 208-223. https://doi.org/10.35891/cb0dn991
Vancouver
Lumbangaol Y, Irwan H. Analysis of Hydrotest Failure Risk on Line Pipe System Using Failure Mode and Effects Analysis (FMEA) Method. JKIE (Journal Knowledge Industrial Engineering). 2026;12(2):208-223. doi:10.35891/cb0dn991
BibTeX
@article{Lumbangaol2026,
author = {Lumbangaol, Yruan and Irwan, Hery},
title = {Analysis of Hydrotest Failure Risk on Line Pipe System Using Failure Mode and Effects Analysis (FMEA) Method},
journal = {JKIE (Journal Knowledge Industrial Engineering)},
year = {2026},
volume = {12},
number = {2},
pages = {208--223},
doi = {10.35891/cb0dn991}
}
EUVIMED