Dynamic Response of Steel Radial Sluice Gate Subjected to Flood-Driven Steel Tube Impact
Water · 28.02.2026 · 18 (5) · 586
DOI: 10.3390/w18050586 ↗Kurz gefasst
Fachartikel in der Zeitschrift Water, online erschienen am 28.02.2026. Verfasst von Changli Li und 3 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 53 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, Independent Research Project of State Key Laboratory of Simulation and Regulation of Water Cycle in River Basin, State Key Laboratory of Water Cycle and Water Security.
Abstract (Originalsprache)
Sluice gates are critical infrastructure for flood mitigation. During extreme floods, steel tubes from upstream sites can be transported downstream and impact radial gates, a scenario reported by operators but lacking systematic investigation. This study investigates the dynamic response and damage characteristics of a steel radial gate subjected to such impacts. A finite element model of an in-service radial gate was developed using shell elements. The Johnson–Cook constitutive model was adopted to capture the strain-rate hardening and to quantify the damage extent of Q235 steel. Numerical simulations were conducted across various impact scenarios, comparing the effects of a realistic steel tube against a mass-equivalent spherical impactor, and analyzing the influence of tube size, velocity, angle, and impact location. The results demonstrate that using a mass-equivalent spherical model yields unsafe estimates, underestimating the impact impulse and maximum total displacement by up to 10.58% and 26.16%, respectively, and under-predicting the damage parameter by as much as 51.53% in certain conditions. The maximum gate displacement (885.2 mm) occurs when the tube strikes near the top edge, while the most severe damage (parameter 0.53) is observed near the main crossbeam-support arm joint. The analysis further identifies two primary deformation modes under tube impact: local bending and a cantilever plate deformation. The latter, occurring at top-corner impacts, induces large displacements and forms a plastic hinge line, causing critical damage that is remote from the initial impact point. This research provides quantitative insights that are necessary for the anti-collision design and vulnerability assessment of radial gates. The findings underscore the need to consider realistic impactor geometry in structural analyses, contributing to enhanced risk management and the operational resilience of flood-control infrastructure during extreme flood events.
Förderung
- National Natural Science Foundation of China
- Independent Research Project of State Key Laboratory of Simulation and Regulation of Water Cycle in River Basin
- State Key Laboratory of Water Cycle and Water Security
- IWHR Research & Development Support Program
Zitieren
APA
Li, C., Zhang, X., Li, M., & Liu, Z. (2026). Dynamic Response of Steel Radial Sluice Gate Subjected to Flood-Driven Steel Tube Impact. Water, 18(5), 586. https://doi.org/10.3390/w18050586
Vancouver
Li C, Zhang X, Li M, Liu Z. Dynamic Response of Steel Radial Sluice Gate Subjected to Flood-Driven Steel Tube Impact. Water. 2026;18(5):586. doi:10.3390/w18050586
BibTeX
@article{Li2026,
author = {Li, Changli and Zhang, Xuan and Li, Meng and Liu, Zhe},
title = {Dynamic Response of Steel Radial Sluice Gate Subjected to Flood-Driven Steel Tube Impact},
journal = {Water},
year = {2026},
volume = {18},
number = {5},
pages = {586},
doi = {10.3390/w18050586}
}
EUVIMED