A Calibrated 3D Vector-Projection Method for Estimating Clothing Pressure from Digital Garment-Mesh Deformation
Textiles · 24.07.2026 · 6 (3) · 91
DOI: 10.3390/textiles6030091 ↗Kurz gefasst
Fachartikel in der Zeitschrift Textiles, online erschienen am 24.07.2026. Verfasst von Seyoung Jeon und 1 weiteren Autor:innen. Die Arbeit nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Research Foundation of Korea, Kongju National University.
Abstract (Originalsprache)
Clothing pressure is a critical design parameter in compression garments, yet its estimation in three-dimensional (3D) digital environments remains challenging because it depends on fabric mechanics, garment deformation, body geometry, and garment–body contact. This study developed a calibrated 3D vector-projection method for estimating clothing pressure from digital garment-mesh deformation. The method was based on the mechanical premise that garment extension generates in-plane tensile forces, whereas interface pressure is associated with the component of those forces acting normal to the body surface. Accordingly, corresponding flat and deformed garment meshes from CLO 3D were used to calculate edge-length strain and internal force; resultant forces were projected onto local avatar-normal directions and normalized by vertex-associated surface area to obtain uncalibrated pressure-related values. Five tricot fabrics and two pattern-reduction levels were used to produce ten compression tops, and pressure measured at five body locations was used for modulus-group-specific linear calibration to account for stiffness-dependent differences in deformation-to-pressure conversion. Under leave-one-garment-out cross-validation, the final linear model achieved an overall R2 of 0.563, an RMSE of 0.587 kPa, and an MAE of 0.427 kPa. A 1–15 mm contact-distance analysis identified 10 mm as a conservative numerical stabilization point, with normalized means remaining within ±2% of the 15 mm reference and adjacent-threshold changes below 0.1 from 10 to 15 mm. The proposed method provides a transparent, mechanics-informed mesh-level procedure that converts digital garment deformation into calibrated body-normal pressure estimates and 3D spatial maps without treating commercial virtual-fitting pressure maps as direct physical predictions.
Förderung
- National Research Foundation of Korea
- Kongju National University
Zitieren
APA
Jeon, S., & Lee, H. (2026). A Calibrated 3D Vector-Projection Method for Estimating Clothing Pressure from Digital Garment-Mesh Deformation. Textiles, 6(3), 91. https://doi.org/10.3390/textiles6030091
Vancouver
Jeon S, Lee H. A Calibrated 3D Vector-Projection Method for Estimating Clothing Pressure from Digital Garment-Mesh Deformation. Textiles. 2026;6(3):91. doi:10.3390/textiles6030091
BibTeX
@article{Jeon2026,
author = {Jeon, Seyoung and Lee, Hyojeong},
title = {A Calibrated 3D Vector-Projection Method for Estimating Clothing Pressure from Digital Garment-Mesh Deformation},
journal = {Textiles},
year = {2026},
volume = {6},
number = {3},
pages = {91},
doi = {10.3390/textiles6030091}
}
EUVIMED