EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Measurement of Light-Duty Vehicle Exhaust Emissions with Light Absorption Spectrometers

Barouch Giechaskiel, Anastasios Melas, Jacopo Franzetti, Victor Valverde, Michaël Clairotte, Ricardo Suarez-Bertoa

Technologies · 28.02.2024 · 12 (3) · 32

DOI: 10.3390/technologies12030032 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Technologies, online erschienen am 28.02.2024. Verfasst von Barouch Giechaskiel und 5 weiteren Autor:innen. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 116 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Light-duty vehicle emission regulations worldwide set limits for the following gaseous pollutants: carbon monoxide (CO), nitric oxides (NOX), hydrocarbons (HCs), and/or non-methane hydrocarbons (NMHCs). Carbon dioxide (CO2) is indirectly limited by fleet CO2 or fuel consumption targets. Measurements are carried out at the dilution tunnel with “standard” laboratory-grade instruments following well-defined principles of operation: non-dispersive infrared (NDIR) analyzers for CO and CO2, flame ionization detectors (FIDs) for hydrocarbons, and chemiluminescence analyzers (CLAs) or non-dispersive ultraviolet detectors (NDUVs) for NOX. In the United States in 2012 and in China in 2020, with Stage 6, nitrous oxide (N2O) was also included. Brazil is phasing in NH3 in its regulation. Alternative instruments that can measure some or all these pollutants include Fourier transform infrared (FTIR)- and laser absorption spectroscopy (LAS)-based instruments. In the second category, quantum cascade laser (QCL) spectroscopy in the mid-infrared area or laser diode spectroscopy (LDS) in the near-infrared area, such as tunable diode laser absorption spectroscopy (TDLAS), are included. According to current regulations and technical specifications, NH3 is the only component that has to be measured at the tailpipe to avoid ammonia losses due to its hydrophilic properties and adsorption on the transfer lines. There are not many studies that have evaluated such instruments, in particular those for “non-regulated” worldwide pollutants. For this reason, we compared laboratory-grade “standard” analyzers with FTIR- and TDLAS-based instruments measuring NH3. One diesel and two gasoline vehicles at different ambient temperatures and with different test cycles produced emissions in a wide range. In general, the agreement among the instruments was very good (in most cases, within ±10%), confirming their suitability for the measurement of pollutants.

Zitieren

APA

Giechaskiel, B., Melas, A., Franzetti, J., Valverde, V., Clairotte, M., & Suarez-Bertoa, R. (2024). Measurement of Light-Duty Vehicle Exhaust Emissions with Light Absorption Spectrometers. Technologies, 12(3), 32. https://doi.org/10.3390/technologies12030032

Vancouver

Giechaskiel B, Melas A, Franzetti J, Valverde V, Clairotte M, Suarez-Bertoa R. Measurement of Light-Duty Vehicle Exhaust Emissions with Light Absorption Spectrometers. Technologies. 2024;12(3):32. doi:10.3390/technologies12030032

BibTeX
@article{Giechaskiel2024,
  author = {Giechaskiel, Barouch and Melas, Anastasios and Franzetti, Jacopo and Valverde, Victor and Clairotte, Michaël and Suarez-Bertoa, Ricardo},
  title = {Measurement of Light-Duty Vehicle Exhaust Emissions with Light Absorption Spectrometers},
  journal = {Technologies},
  year = {2024},
  volume = {12},
  number = {3},
  pages = {32},
  doi = {10.3390/technologies12030032}
}
Kostenlos starten →