EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Symmetrical Martensite Distribution in Wire Using Cryogenic Cooling

Irina Volokitina, Andrey Volokitin, Evgeniy Panin, Bolat Makhmutov

Symmetry · 07.09.2024 · 16 (9) · 1174

DOI: 10.3390/sym16091174 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Symmetry, online erschienen am 07.09.2024. Verfasst von Irina Volokitina und 3 weiteren Autor:innen. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 46 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Science Committee of the Ministry of Science and Higher Education of the Republic of Kazakhstan.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This article presents the results of research on a new combined process involving multi-cycle wire-drawing and subsequent cryogenic cooling after each deformation stage. For theoretical research, modeling in the Deform software was performed. The analysis of temperature fields and the martensitic component in all models showed that for both considered thicknesses, the most effective option is a low deformation velocity and the conduct of a process without heating. The least effective option is to use an increased thickness of the workpiece at an increased deformation velocity and the conduct of a process without of heating to ambient temperature, which acts as a local cooling of the axial zone of the workpiece with an increase in the workpiece thickness. An analysis of laboratory studies on this combined process revealed that in the absence of intermediate heating of a wire between deformation cycles, 100% martensite is formed in the structure. However, if intermediate heating to 20 °C between deformation cycles is carried out, a gradient distribution of martensite can be obtained. And, since the wire has a circular cross-section, in all cases, martensite is distributed symmetrically about the center of the workpiece.

Förderung

  • Science Committee of the Ministry of Science and Higher Education of the Republic of Kazakhstan

Zitieren

APA

Volokitina, I., Volokitin, A., Panin, E., & Makhmutov, B. (2024). Symmetrical Martensite Distribution in Wire Using Cryogenic Cooling. Symmetry, 16(9), 1174. https://doi.org/10.3390/sym16091174

Vancouver

Volokitina I, Volokitin A, Panin E, Makhmutov B. Symmetrical Martensite Distribution in Wire Using Cryogenic Cooling. Symmetry. 2024;16(9):1174. doi:10.3390/sym16091174

BibTeX
@article{Volokitina2024,
  author = {Volokitina, Irina and Volokitin, Andrey and Panin, Evgeniy and Makhmutov, Bolat},
  title = {Symmetrical Martensite Distribution in Wire Using Cryogenic Cooling},
  journal = {Symmetry},
  year = {2024},
  volume = {16},
  number = {9},
  pages = {1174},
  doi = {10.3390/sym16091174}
}
Kostenlos starten →