Study on the Current Carrying Friction and Wear Performance of Conductive Rollers for Ni-Cr Electroplating at High Current Density
Surfaces · 10.11.2026 · 9 (4) · 96
DOI: 10.3390/surfaces9040096 ↗Kurz gefasst
Fachartikel in der Zeitschrift Surfaces, online erschienen am 10.11.2026. Verfasst von Rui Wang und 4 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Key Research and Development Program of China, the Guangdong Basic and Applied Basic Research Foundation.
Abstract (Originalsprache)
Conductive rollers in Ni-Cr electroplating require wear-resistant surfaces under current-carrying contact. Ag coatings are susceptible to deformation and wear, while the protective response of Ag-Cu coatings under lubricated current-carrying sliding remains insufficiently characterized. In this study, an Ag-Cu coating was prepared on a T2 Cu substrate by rotary spray deposition and evaluated through microstructural characterization, nanoindentation, and sliding tests. Current-carrying friction tests were conducted at 20 N under PAO 10 lubrication for 30 min. The coating exhibited a higher mean hardness (1.943 ± 0.997 GPa vs. 1.055 ± 0.070 GPa) than the substrate. At 20 A, the coating maintained a coefficient of friction of approximately 0.12 and exhibited a wear volume of 2.44 × 10−3 mm3 within the measured region, 19.7% lower than that of the substrate. Morphological and elemental observations were consistent with oxidation and material redistribution. No clear overall advantage was observed at 10 A, whereas severe damage occurred at 30 A despite lower friction. These results indicate a protective benefit at 20 A under the tested conditions and support further evaluation of Ag-Cu coatings for conductive roller protection.
Förderung
- National Key Research and Development Program of China
- the Guangdong Basic and Applied Basic Research Foundation
Zitieren
APA
Wang, R., Zhang, P., Xue, D., Chen, D., & Wang, Q. (2026). Study on the Current Carrying Friction and Wear Performance of Conductive Rollers for Ni-Cr Electroplating at High Current Density. Surfaces, 9(4), 96. https://doi.org/10.3390/surfaces9040096
Vancouver
Wang R, Zhang P, Xue D, Chen D, Wang Q. Study on the Current Carrying Friction and Wear Performance of Conductive Rollers for Ni-Cr Electroplating at High Current Density. Surfaces. 2026;9(4):96. doi:10.3390/surfaces9040096
BibTeX
@article{Wang2026,
author = {Wang, Rui and Zhang, Peng and Xue, Dingqi and Chen, Dexin and Wang, Qiwei},
title = {Study on the Current Carrying Friction and Wear Performance of Conductive Rollers for Ni-Cr Electroplating at High Current Density},
journal = {Surfaces},
year = {2026},
volume = {9},
number = {4},
pages = {96},
doi = {10.3390/surfaces9040096}
}
EUVIMED