EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The Effect of Co/TiN Interfaces on Co Interconnect Resistivity

Poyen Shen, Sanzida Rahman, Daniel M. Syracuse, Daniel Gall

Surfaces · 13.12.2025 · 8 (4) · 89

DOI: 10.3390/surfaces8040089 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Surfaces, online erschienen am 13.12.2025. Verfasst von Poyen Shen und 3 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 87 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Semiconductor Research Corporation, U.S. National Science Foundation, New York State Foundation for Science, Technology and Innovation.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Electron transport measurements on Co/TiN multilayers are employed to explore the effect of TiN layers on Co resistivity. For this, 50 nm thick multilayer stacks containing N = 1–10 individual Co layers that are separated by 1 nm thick TiN layers are sputter deposited on SiO2/Si(001) substrates at 400 °C. X-ray diffraction and reflectivity measurements indicate a tendency for a 0001 preferred orientation, an X-ray coherence length of 13 nm that is nearly independent of N, and an interfacial roughness that increases with N. The in-plane multilayer resistivity ρ increases with increasing N = 1–10, from ρ = 14.4 to 36.6 µΩ-cm at room temperature and from ρ = 11.2 to 19.4 µΩ-cm at 77 K. This increase is due to a combination of increased electron scattering at interfaces and grain boundaries, as quantified using a combined Fuchs–Sondheimer and Mayadas–Shatzkes model. The analysis indicates that a decreasing thickness of the individual Co layers dCo from 50 to 5 nm causes not only an increasing resistivity contribution from Co/TiN interface scattering (from 9 to 88% with respect to the room-temperature bulk resistivity) but also an increasing (39 to 154%) grain boundary scattering contribution, which exacerbates the resistivity penalty due to the TiN liner. These results are supported by Co/TiN bilayer and trilayer structures deposited on Al2O3 (0001) at 600 °C. Interfacial intermixing causes Co2Ti and Co3Ti alloy phase formation, an increase in the contact resistance, a degradation of the Co crystalline quality, and a 2.3× higher resistivity for Co deposited on TiN than Co directly deposited on Al2O3(0001). The overall results show that TiN liners cause a dramatic increase in Co interconnects due to diffuse surface scattering, interfacial intermixing/roughness, and Co grain renucleation at Co/TiN interfaces.

Förderung

  • Semiconductor Research Corporation
  • U.S. National Science Foundation
  • New York State Foundation for Science, Technology and Innovation

Zitieren

APA

Shen, P., Rahman, S., Syracuse, D. M., & Gall, D. (2025). The Effect of Co/TiN Interfaces on Co Interconnect Resistivity. Surfaces, 8(4), 89. https://doi.org/10.3390/surfaces8040089

Vancouver

Shen P, Rahman S, Syracuse DM, Gall D. The Effect of Co/TiN Interfaces on Co Interconnect Resistivity. Surfaces. 2025;8(4):89. doi:10.3390/surfaces8040089

BibTeX
@article{Shen2025,
  author = {Shen, Poyen and Rahman, Sanzida and Syracuse, Daniel M. and Gall, Daniel},
  title = {The Effect of Co/TiN Interfaces on Co Interconnect Resistivity},
  journal = {Surfaces},
  year = {2025},
  volume = {8},
  number = {4},
  pages = {89},
  doi = {10.3390/surfaces8040089}
}
Kostenlos starten →