EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Reheating and Roller Forming of Aluminum Foam Fabricated by Foaming Precursor

Yoshihiko Hangai, Kentaro Ishiuchi, Kenji Amagai, Nobuhiro Yoshikawa

Solids · 02.03.2026 · 7 (2) · 13

DOI: 10.3390/solids7020013 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Solids, online erschienen am 02.03.2026. Verfasst von Yoshihiko Hangai und 3 weiteren Autor:innen. Die Arbeit nennt 57 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Light Metal Education Foundation, Amada Foundation.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Aluminum foam is expected to be applied in various industrial fields as a lightweight, multifunctional material. When it is used as an industrial product, it is essential to form it into the required shape. There have been some attempts to form aluminum foam. However, the formability remains low. In this study, we attempted to form aluminum foam, which was fabricated by heat foaming a precursor, into a flat plate by reheating it above its foaming temperature and then roller forming it. It was found that heating above the foaming temperature and subsequent roller forming enabled the aluminum foam to be formed into a flat plate without causing defects. In a sample in which the precursor was roller-formed immediately after foaming, it was found that compared to the as-foamed aluminum foam, the decrease in porosity was limited to approximately 5%, enabling roller forming while minimizing the influences on pore structures. In samples that were roller-formed after reheating, porosities slightly decreased, but most pores were retained. Even when the aluminum foam was roller-formed to the same thickness as the initial precursor before foaming, the porosities exhibited around 65%, limiting the reduction in porosities to approximately 15% compared to the as-foamed aluminum foam.

Förderung

  • Light Metal Education Foundation
  • Amada Foundation

Zitieren

APA

Hangai, Y., Ishiuchi, K., Amagai, K., & Yoshikawa, N. (2026). Reheating and Roller Forming of Aluminum Foam Fabricated by Foaming Precursor. Solids, 7(2), 13. https://doi.org/10.3390/solids7020013

Vancouver

Hangai Y, Ishiuchi K, Amagai K, Yoshikawa N. Reheating and Roller Forming of Aluminum Foam Fabricated by Foaming Precursor. Solids. 2026;7(2):13. doi:10.3390/solids7020013

BibTeX
@article{Hangai2026,
  author = {Hangai, Yoshihiko and Ishiuchi, Kentaro and Amagai, Kenji and Yoshikawa, Nobuhiro},
  title = {Reheating and Roller Forming of Aluminum Foam Fabricated by Foaming Precursor},
  journal = {Solids},
  year = {2026},
  volume = {7},
  number = {2},
  pages = {13},
  doi = {10.3390/solids7020013}
}
Kostenlos starten →