EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Probe Wave Parameter Optimization for Vibro-Acoustic Modulation in Bolt Loosening Monitoring

Shengyu Peng, Yu Wang, Peng Xu

Sensors · 16.11.2026 · 26 (22) · 7227

DOI: 10.3390/s26227227 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 16.11.2026. Verfasst von Shengyu Peng und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Bolted joints, as critical load-transferring components in large-scale equipment, require effective loosening monitoring to ensure structural safety. Vibro-acoustic modulation (VAM) has attracted considerable attention in bolt loosening monitoring due to its high sensitivity to contact-type defects, yet the influence of fundamental probe wave parameters remains insufficiently explored. In this paper, a theoretical relationship among the modulation amplitudes of the transmitted and reflected waves, the interface pressure, and the probe wave frequency was established based on contact acoustic nonlinearity (CAN) theory. Two complementary modulation indices, a logarithmic index and an integral-based index, were constructed, and systematic experiments on a bolted joint were conducted to analyze the influence of probe wave parameters. The results demonstrate that the logarithmic modulation index offers better stability than the integral-based one. A lower sweep rate is the primary factor in suppressing phase-induced background noise and improving the stability of the modulation index. While a wider swept-frequency range provides a more comprehensive response, it inherently increases the sweep rate under a fixed duration, leading to severe noise near the pump frequency. Therefore, optimizing the sweep rate is crucial for enhancing the identification accuracy of incipient bolt loosening. Theoretically, the frequency dependence is non-monotonic due to the stiffness-impedance balance, and an optimum frequency range exists. However, higher probe frequencies are inferred to induce a spatial focusing effect toward the central high-pressure zone, which significantly enhances the separation of modulation indices under different bolt torques. Moreover, the observed frequency-selective band (140–160kHz) is attributed to a local structural wave-trapping effect at the lap joint, which significantly amplifies the contact acoustic nonlinearity. By tuning the probe wave within this localized resonant band and controlling the sweep rate, the monitoring sensitivity is substantially improved, providing explicit practical guidelines for probe parameter selection.

Zitieren

APA

Peng, S., Wang, Y., & Xu, P. (2026). Probe Wave Parameter Optimization for Vibro-Acoustic Modulation in Bolt Loosening Monitoring. Sensors, 26(22), 7227. https://doi.org/10.3390/s26227227

Vancouver

Peng S, Wang Y, Xu P. Probe Wave Parameter Optimization for Vibro-Acoustic Modulation in Bolt Loosening Monitoring. Sensors. 2026;26(22):7227. doi:10.3390/s26227227

BibTeX
@article{Peng2026,
  author = {Peng, Shengyu and Wang, Yu and Xu, Peng},
  title = {Probe Wave Parameter Optimization for Vibro-Acoustic Modulation in Bolt Loosening Monitoring},
  journal = {Sensors},
  year = {2026},
  volume = {26},
  number = {22},
  pages = {7227},
  doi = {10.3390/s26227227}
}
Kostenlos starten →