MoS2/HfO2 Heterostructure Interface Engineering for Stable and Reproducible Resistive Switching in Ag/HfO2/TiN Memristors for Intelligent Sensor Nodes
Sensors · 06.11.2026 · 26 (21) · 7035
DOI: 10.3390/s26217035 ↗Kurz gefasst
Fachartikel in der Zeitschrift Sensors, online erschienen am 06.11.2026. Verfasst von Ya-Zhou Zhou und 5 weiteren Autor:innen. Beteiligte Einrichtung: School of Mechanical Engineering, Jiangsu University, Zhenjiang 212013, China. Die Arbeit nennt 53 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Resistive switching devices are attractive candidates for nonvolatile memory and sensory information storage in intelligent sensor nodes, but their use near sensors remains limited by switching variability and resistance state instability. In this work, a two-dimensional MoS2 interlayer is introduced into an Ag/HfO2/TiN memristor stack to form a MoS2/HfO2 heterostructure device, and its electrical characteristics are compared with an Ag/HfO2/TiN control device fabricated under the same oxide deposition and annealing conditions. The heterostructure device exhibits well-defined and reproducible bipolar resistive switching with an on/off ratio of up to approximately 103, together with markedly improved cycle-to-cycle overlap of the current-voltage characteristics, whereas the switching window of the control device narrows and eventually closes after repeated sweeps. X-ray photoelectron spectroscopy of the O 1s core level shows that the oxygen-vacancy-related component decreases from 18.31% to 5.12% of the fitted spectral envelope after introduction of the MoS2 interlayer, while the lattice-oxygen component remains essentially unchanged. This selective reduction is attributed to interfacial passivation of electrically active vacancies rather than to bulk oxygen extraction, and it cannot be explained by signal attenuation of the buried oxide under the MoS2 overlayer. Retention measurements show that the heterostructure device maintains stable high- and low-resistance states over the measured 103 s window, while the high-resistance state of the control device decays by orders of magnitude within the same period. The switching polarity, the correlation between vacancy chemistry and switching uniformity, and the stability of the ruptured-filament state are consistent with an interface-guided valence-change mechanism, although a minor contribution of Ag-ion migration cannot be excluded. These results indicate that MoS2/HfO2 heterojunction engineering is an effective route toward mitigating variability and retention degradation in oxide-based memristors for intelligent sensing hardware. The measured resistance window, repeatable switching, and state retention are relevant to local storage of sensor features, calibration coefficients, and adaptive thresholds in robotic perception. The present work establishes the memory component of such sensor nodes and does not claim direct transduction or a complete robotic sensing system.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- School of Mechanical Engineering, Jiangsu University, Zhenjiang 212013, China.
- College of Ocean, Jiangsu University of Science and Technology, Zhenjiang 212000, China.
- Suzhou Yuanzi Intelligent Technology Co., Ltd., Suzhou 215000, China.
ORCID-Profile: Nan Zhou
Zitieren
APA
Zhou, Y. Z., Fang, L. T., Zhou, Z. N., Zhou, N., Wang, Y., & Shan, F. (2026). MoS2/HfO2 Heterostructure Interface Engineering for Stable and Reproducible Resistive Switching in Ag/HfO2/TiN Memristors for Intelligent Sensor Nodes. Sensors, 26(21), 7035. https://doi.org/10.3390/s26217035
Vancouver
Zhou YZ, Fang LT, Zhou ZN, Zhou N, Wang Y, Shan F. MoS2/HfO2 Heterostructure Interface Engineering for Stable and Reproducible Resistive Switching in Ag/HfO2/TiN Memristors for Intelligent Sensor Nodes. Sensors. 2026;26(21):7035. doi:10.3390/s26217035
BibTeX
@article{Zhou2026,
author = {Zhou, Ya-Zhou and Fang, Le-Tian and Zhou, Zhen-Nan and Zhou, Nan and Wang, Yun and Shan, Fei},
title = {MoS2/HfO2 Heterostructure Interface Engineering for Stable and Reproducible Resistive Switching in Ag/HfO2/TiN Memristors for Intelligent Sensor Nodes},
journal = {Sensors},
year = {2026},
volume = {26},
number = {21},
pages = {7035},
doi = {10.3390/s26217035}
}
EUVIMED