EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Ca3Co4O9-Based Planar Thermoelectric Gas Sensor with High Sensitivity Fabricated by Powder Aerosol Deposition for Application in Harsh Environments

Benedikt Streibl, Thomas Wöhrl, Daniel Paulus iD, Jaroslaw Kita iD, Daniela Schönauer-Kamin iD, Gunter Hagen iD, Ralf Moos iD

Sensors · 02.08.2026 · 26 (15) · 4864

DOI: 10.3390/s26154864 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 02.08.2026. Verfasst von Benedikt Streibl und 6 weiteren Autor:innen. Beteiligte Einrichtung: Department of Functional Materials, Zentrum für Energietechnik (ZET), University of Bayreuth, D-95440 Bayreuth, Germany. Die Arbeit nennt 58 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Increasingly stringent emission regulations in combustion systems drive the demand for robust, cost-effective gas sensors capable of operating under harsh, high-temperature conditions. Thermoelectric ceramic gas sensors represent a promising approach. Their application, however, may be limited owing to a low response. In this work, calcium cobaltite (CCO), a p-type thermoelectric oxide with a Seebeck coefficient higher than most metals used for thermocouples, is investigated as an alternative material to enhance sensor performance. CCO powder was synthesized via the mixed oxide route and deposited as dense ceramic films onto alumina substrates at room temperature using the powder aerosol deposition method (PAD). The thermoelectric properties of the deposited films were characterized up to 850 °C, with the Seebeck coefficient showing only minor dependencies on variations in oxygen and water vapor concentrations. Following these results, planar exothermic gas sensors based on Au/CCO thermocouples utilizing laser-cut polyimide masks for patterning the PAD films were fabricated and compared to reference sensors with screen-printed metallic Au/Pt thermocouples. Laboratory gas measurements with CO and hydrocarbons demonstrated that the Au/CCO-based sensors exhibited an average sensitivity increase by a factor of 8–9, while maintaining high linearity and low cross-sensitivity to variations in oxygen and humidity. Furthermore, the additive response to gas mixtures was confirmed. Initial tests in real flue gas from a wood-burning stove showed an excellent correlation between the sensor signal and relevant flue gas components (measured using precise gas analyzers). The presented results highlight the potential of calcium cobaltite as a thermoelectric material for high-temperature gas sensors based on the exothermic principle and demonstrate the suitability of the PAD method for fabricating fine-structured functional films.

Schlagwörter

Stichwörter der Autor:innen

calcium cobaltiteflue gaspowder aerosol depositionthermoelectric gas sensor

Autor:innen und Institutionen

  • Department of Functional Materials, Zentrum für Energietechnik (ZET), University of Bayreuth, D-95440 Bayreuth, Germany.

ORCID-Profile: Daniel Paulus, Jaroslaw Kita, Daniela Schönauer-Kamin, Gunter Hagen, Ralf Moos

Zitieren

APA

Streibl, B., Wöhrl, T., Paulus, D., Kita, J., Schönauer-Kamin, D., Hagen, G., & Moos, R. (2026). Ca3Co4O9-Based Planar Thermoelectric Gas Sensor with High Sensitivity Fabricated by Powder Aerosol Deposition for Application in Harsh Environments. Sensors, 26(15), 4864. https://doi.org/10.3390/s26154864

Vancouver

Streibl B, Wöhrl T, Paulus D, Kita J, Schönauer-Kamin D, Hagen G, et al. Ca3Co4O9-Based Planar Thermoelectric Gas Sensor with High Sensitivity Fabricated by Powder Aerosol Deposition for Application in Harsh Environments. Sensors. 2026;26(15):4864. doi:10.3390/s26154864

BibTeX
@article{Streibl2026,
  author = {Streibl, Benedikt and Wöhrl, Thomas and Paulus, Daniel and Kita, Jaroslaw and Schönauer-Kamin, Daniela and Hagen, Gunter and Moos, Ralf},
  title = {Ca3Co4O9-Based Planar Thermoelectric Gas Sensor with High Sensitivity Fabricated by Powder Aerosol Deposition for Application in Harsh Environments},
  journal = {Sensors},
  year = {2026},
  volume = {26},
  number = {15},
  pages = {4864},
  doi = {10.3390/s26154864}
}
Kostenlos starten →