EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Low-Temperature Ammonia Sensing Using Sulfurized WS2 Thin Films

Naman Kumar iD, Ivan Hotový iD, Magdaléna Kadlečíková iD, Michaela Sojková iD, Ivan Kostič iD, Dagmar Gregušová, Ondrej Pohorelec iD, Viera Stopjaková iD, Edmund Dobročka

Sensors · 12.07.2026 · 26 (14) · 4429

DOI: 10.3390/s26144429 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 12.07.2026. Verfasst von Naman Kumar und 8 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Electrical Engineering and Information Technology, Slovak University of Technology, Ilkovičova 3, 81219 Bratislava, Slovakia. Die Arbeit nennt 52 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Education, Science, Research and Sport of the Slovak Republic, Slovak Research and Development Agency, the Chips Joint Undertaking.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study addresses key challenges in gas sensing, particularly achieving high sensitivity at low operating temperatures. Tungsten disulfide (WS2) thin films were deposited by sputtering and sulfurized at 800 °C for 30 and 60 min on quartz and sapphire substrates. Raman spectroscopy confirmed multilayer WS2 formation, with characteristic modes at 349 and 417 cm−1. X-ray diffraction revealed that the films are polycrystalline with the formation of the hexagonal 2H-WS2 phase on both substrates. FESEM images showed clearly visible nanoparticles, but they were not evenly distributed and were differently oriented, with a hint of texturing. The WS2 films exhibited stable sensing performance at low operating temperatures from 30 to 150 °C and high sensitivity toward NH3 in the 10–200 ppm range. Experimental results indicate a limit of detection, highlighting the potential of WS2 films for low operating temperature ammonia sensing. A minimum value of the limit of detection of 0.6 ppm for an operating temperature of 150 °C was achieved for the WS2 sample sulfurized at 800 °C for 60 min on a quartz substrate.

Schlagwörter

Stichwörter der Autor:innen

NH3 gas sensinggas response and sensitivitymagnetron sputteringsulfurizationtungsten disulfide (WS2)

Autor:innen und Institutionen

  • Faculty of Electrical Engineering and Information Technology, Slovak University of Technology, Ilkovičova 3, 81219 Bratislava, Slovakia.
  • Institute of Informatics, Slovak Academy of Sciences, Dúbravská cesta 9, 84507 Bratislava, Slovakia.
  • Institute of Electrical Engineering, Slovak Academy of Sciences, Dúbravská cesta 9, 84104 Bratislava, Slovakia.

ORCID-Profile: Naman Kumar, Ivan Hotový, Magdaléna Kadlečíková, Michaela Sojková, Ivan Kostič, Ondrej Pohorelec, Viera Stopjaková

Förderung

  • Ministry of Education, Science, Research and Sport of the Slovak Republic
  • Slovak Research and Development Agency
  • the Chips Joint Undertaking

Zitieren

APA

Kumar, N., Hotový, I., Kadlečíková, M., Sojková, M., Kostič, I., Gregušová, D., Pohorelec, O., Stopjaková, V., & Dobročka, E. (2026). Low-Temperature Ammonia Sensing Using Sulfurized WS2 Thin Films. Sensors, 26(14), 4429. https://doi.org/10.3390/s26144429

Vancouver

Kumar N, Hotový I, Kadlečíková M, Sojková M, Kostič I, Gregušová D, et al. Low-Temperature Ammonia Sensing Using Sulfurized WS2 Thin Films. Sensors. 2026;26(14):4429. doi:10.3390/s26144429

BibTeX
@article{Kumar2026,
  author = {Kumar, Naman and Hotový, Ivan and Kadlečíková, Magdaléna and Sojková, Michaela and Kostič, Ivan and Gregušová, Dagmar and Pohorelec, Ondrej and Stopjaková, Viera and Dobročka, Edmund},
  title = {Low-Temperature Ammonia Sensing Using Sulfurized WS2 Thin Films},
  journal = {Sensors},
  year = {2026},
  volume = {26},
  number = {14},
  pages = {4429},
  doi = {10.3390/s26144429}
}
Kostenlos starten →