EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Design and Evaluation of a Flexible Substrate-Based Microstrip Sensor for Partial Discharge Detection in High-Voltage Equipment

Shuhao Dong, Xiao Hu

Sensors · 22.05.2026 · 26 (11) · 3304

DOI: 10.3390/s26113304 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 22.05.2026. Verfasst von Shuhao Dong und 1 weiteren Autor:innen. Beteiligte Einrichtung: College of Electrical Engineering, Guizhou University, Guiyang 550025, China. Die Arbeit nennt 25 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Guizhou Provincial Science and Technology Department.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Partial discharge (PD) detection effectively identifies insulation defects in power equipment. Radio frequency (RF) methods for PD detection offer promising advantages due to their non-invasive measurement capability and ability to locate discharge sources. However, microstrip antennas used as RF sensors for PD detection suffer from narrow bandwidth and limited installation flexibility. To address these limitations, this paper presents a novel flexible microstrip antenna design. By incorporating a partial ground plane and oblique-cut meandering techniques and optimizing the structural parameters using an improved whale optimization algorithm (I-WOA), the operating bandwidth is expanded from 0.612–0.625 GHz to 0.346–2.0 GHz, while the overall size is reduced to 75.3% of its original dimensions. The antenna’s performance was validated through GTEM cell measurements and PD calibration pulse tests, confirming its suitability for RF detection of PD in power equipment such as transformers and cable joints. Notably, when the antenna was conformally wrapped around a cable joint, the response amplitude increased by 14%. This study contributes to the development of a low-cost, broadband, and flexibly installable RF sensor for partial discharge detection.

Schlagwörter

Stichwörter der Autor:innen

GTEM cellcable jointmicrostrip antennapartial discharge (PD)power transformerwhale optimization algorithm (WOA)

Autor:innen und Institutionen

  • College of Electrical Engineering, Guizhou University, Guiyang 550025, China.

Förderung

  • Guizhou Provincial Science and Technology Department

Zitieren

APA

Dong, S., & Hu, X. (2026). Design and Evaluation of a Flexible Substrate-Based Microstrip Sensor for Partial Discharge Detection in High-Voltage Equipment. Sensors, 26(11), 3304. https://doi.org/10.3390/s26113304

Vancouver

Dong S, Hu X. Design and Evaluation of a Flexible Substrate-Based Microstrip Sensor for Partial Discharge Detection in High-Voltage Equipment. Sensors. 2026;26(11):3304. doi:10.3390/s26113304

BibTeX
@article{Dong2026,
  author = {Dong, Shuhao and Hu, Xiao},
  title = {Design and Evaluation of a Flexible Substrate-Based Microstrip Sensor for Partial Discharge Detection in High-Voltage Equipment},
  journal = {Sensors},
  year = {2026},
  volume = {26},
  number = {11},
  pages = {3304},
  doi = {10.3390/s26113304}
}
Kostenlos starten →