EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

FPGA-Based CNN Acceleration on Zynq-7020 for Embedded Ship Recognition in Unmanned Surface Vehicles

Abdelilah Haijoub iD, Aissam Bekkari iD, Anas Hatim, Mounir Arioua, Mohamed Nabil Srifi, Antonio Guerrero-Gonzalez iD

Sensors · 05.03.2026 · 26 (5) · 1626

DOI: 10.3390/s26051626 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 05.03.2026. Verfasst von Abdelilah Haijoub und 5 weiteren Autor:innen. Beteiligte Einrichtung: Engineering Sciences Laboratory, National School of Applied Sciences of Kenitra, Ibn Tofail University, Kenitra 14000, Morocco. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 67 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Unmanned surface vehicles (USVs) increasingly rely on vision-based perception for safe navigation and maritime surveillance, while onboard computing is constrained by strict size, weight, and power (SWaP) budgets. Although deep convolutional neural networks (CNNs) offer strong recognition performance, their computational and memory requirements pose significant challenges for deployment on low-cost embedded platforms. This paper presents a hardware–software co-design architecture and deployment study for CNN acceleration on a heterogeneous ARM–FPGA system, targeting energy-efficient near-sensor processing for embedded maritime applications. The proposed approach exploits a fully streaming hardware architecture in the FPGA fabric, based on line-buffered convolutions and AXI-Stream dataflow, while the ARM processing system is responsible for lightweight configuration, scheduling, and data movement. The architecture was evaluated using representative CNN models trained on a maritime ship dataset. Our experimental results on a Zynq-7020 system-on-chip demonstrate that the proposed co-design strategy achieves a balanced trade-off between throughput, resource utilisation, and power consumption under tight embedded constraints, highlighting its suitability as a practical building block for onboard perception in USVs.

Schlagwörter

Stichwörter der Autor:innen

CNNFPGASWaPVHDLZynq-7020convolutional neural networkship classificationunmanned surface vehicle

Autor:innen und Institutionen

  • Engineering Sciences Laboratory, National School of Applied Sciences of Kenitra, Ibn Tofail University, Kenitra 14000, Morocco.
  • Laboratory of Complex Systems Modeling (LMSC), National School of Applied Sciences of Marrakech, Cadi Ayyad University, Marrakech 40000, Morocco.
  • Laboratory of Research on Sustainable and Innovative Technologies (LaRTID), National School of Applied Sciences of Marrakech, Cadi Ayyad University, Marrakech 40000, Morocco.
  • Department of Automation, Electrical Engineering and Electronic Technology, Universidad Politécnica de Cartagena, 30202 Cartagena, Spain.

ORCID-Profile: Abdelilah Haijoub, Aissam Bekkari, Antonio Guerrero-Gonzalez

Zitieren

APA

Haijoub, A., Bekkari, A., Hatim, A., Arioua, M., Srifi, M. N., & Guerrero-Gonzalez, A. (2026). FPGA-Based CNN Acceleration on Zynq-7020 for Embedded Ship Recognition in Unmanned Surface Vehicles. Sensors, 26(5), 1626. https://doi.org/10.3390/s26051626

Vancouver

Haijoub A, Bekkari A, Hatim A, Arioua M, Srifi MN, Guerrero-Gonzalez A. FPGA-Based CNN Acceleration on Zynq-7020 for Embedded Ship Recognition in Unmanned Surface Vehicles. Sensors. 2026;26(5):1626. doi:10.3390/s26051626

BibTeX
@article{Haijoub2026,
  author = {Haijoub, Abdelilah and Bekkari, Aissam and Hatim, Anas and Arioua, Mounir and Srifi, Mohamed Nabil and Guerrero-Gonzalez, Antonio},
  title = {FPGA-Based CNN Acceleration on Zynq-7020 for Embedded Ship Recognition in Unmanned Surface Vehicles},
  journal = {Sensors},
  year = {2026},
  volume = {26},
  number = {5},
  pages = {1626},
  doi = {10.3390/s26051626}
}
Kostenlos starten →