EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

SWCNT/PEDOT:PSS/SA Composite Yarns with High Mechanical Strength and Flexibility via Wet Spinning for Thermoelectric Applications

Keisuke Uchida, Yoshiyuki Shinozaki, Hiroto Nakayama, Shuya Ochiai, Yuto Nakazawa, Masayuki Takashiri iD

Sensors · 07.10.2025 · 25 (19) · 6202

DOI: 10.3390/s25196202 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 07.10.2025. Verfasst von Keisuke Uchida und 5 weiteren Autor:innen. Beteiligte Einrichtung: Department of Materials Science, Tokai University, 4-1-1 Kitakaname, Hiratsuka 259-1292, Kanagawa, Japan. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 82 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

To fabricate thermoelectric generators (TEGs) with high mechanical strength using single-walled carbon nanotubes (SWCNTs), we combined SWCNTs, poly(3, 4-ethylenedioxythiophene):poly(4-styrenesulfonate) (PEDOT:PSS), and sodium alginate (SA) to synthesize flexible SWCNT/PEDOT:PSS/SA composite yarns via wet spinning. The composite yarns were flexible and dense, with a diameter of approximately 290 µm. Their tensile strength and breaking strain were 151 MPa and 12.7%, respectively, which were approximately 10 and 4 times those of the SWCNT films. However, the thermoelectric properties of the composite yarns were inferior to those of the SWCNT films. The temperature distribution and output voltage of the fabricated TEG with composite yarns were measured at a heater temperature of 100 °C. The temperature difference generated by the TEG with composite yarns was approximately 75% of that generated by the TEG with SWCNT films because the composite yarn had a smaller specific surface area. The output voltage of the TEG with two composite yarns (0.21 mV) was lower than that of the TEG with two SWCNT films. However, arranging the composite yarns at a high density resulted in an output voltage exceeding that for the TEGs with SWCNT films. These findings are highly beneficial for yarn-based TEGs used in wearable sensors.

Schlagwörter

Stichwörter der Autor:innen

PEDOT:PSSSWCNTTEGcomposite yarnsodium alginatewet-spun

Autor:innen und Institutionen

  • Department of Materials Science, Tokai University, 4-1-1 Kitakaname, Hiratsuka 259-1292, Kanagawa, Japan.

ORCID-Profile: Masayuki Takashiri

Zitieren

APA

Uchida, K., Shinozaki, Y., Nakayama, H., Ochiai, S., Nakazawa, Y., & Takashiri, M. (2025). SWCNT/PEDOT:PSS/SA Composite Yarns with High Mechanical Strength and Flexibility via Wet Spinning for Thermoelectric Applications. Sensors, 25(19), 6202. https://doi.org/10.3390/s25196202

Vancouver

Uchida K, Shinozaki Y, Nakayama H, Ochiai S, Nakazawa Y, Takashiri M. SWCNT/PEDOT:PSS/SA Composite Yarns with High Mechanical Strength and Flexibility via Wet Spinning for Thermoelectric Applications. Sensors. 2025;25(19):6202. doi:10.3390/s25196202

BibTeX
@article{Uchida2025,
  author = {Uchida, Keisuke and Shinozaki, Yoshiyuki and Nakayama, Hiroto and Ochiai, Shuya and Nakazawa, Yuto and Takashiri, Masayuki},
  title = {SWCNT/PEDOT:PSS/SA Composite Yarns with High Mechanical Strength and Flexibility via Wet Spinning for Thermoelectric Applications},
  journal = {Sensors},
  year = {2025},
  volume = {25},
  number = {19},
  pages = {6202},
  doi = {10.3390/s25196202}
}
Kostenlos starten →