EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Electronic Noise Measurement of a Magnetoresistive Sensor: A Comparative Study

Cristina Davidaș, Elena Mirela Ștețco, Liviu Marin Viman iD, Mihai Sebastian Gabor, Ovidiu Aurel Pop iD, Traian Petrișor

Sensors · 06.10.2025 · 25 (19) · 6182

DOI: 10.3390/s25196182 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 06.10.2025. Verfasst von Cristina Davidaș und 5 weiteren Autor:innen. Beteiligte Einrichtung: Applied Electronics Department, Technical University of Cluj-Napoca, 400114 Cluj-Napoca, Romania. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 54 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Unitatea Executiva Pentru Finantarea Invatamantului Superior a Cercetarii Dezvoltarii si Inovarii, MRID-CNCS-UEFISCDI, PNCDI IV.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The intrinsic noise of giant magnetoresistive (GMR) sensors is large at low frequencies, and their resolution is inevitably significantly limited. Investigation of GMR noise requires the use of measurement systems that have lower noise than the sample. In this context, the main purpose of this study is to evaluate the effectiveness of two electronic noise measurement configurations of a single GMR sensing element. The first method connects the sample in a voltage divider configuration and the second method connects in a Wheatstone bridge configuration. Three amplification set-ups were investigated: a low-noise amplifier, an ultra-low-noise amplifier and an instrumentation amplifier. Using cross-correlation, the noise of the measurement system introduced by the amplifiers was reduced. Noise spectra were recorded at room temperature in the frequency range of 0.5 Hz to 10 kHz, under different sample bias voltages. The measurements were performed in zero applied magnetic field and in a field corresponding to the maximum sensitivity of the sensor. From the noise spectra, the detectivity of the sensor was determined to be in the 200–300 nT/√Hz range. Good agreement was observed between the results obtained using all three set-ups, suggesting the effectiveness of the noise measurement systems applied to the magnetoresistive sensor.

Schlagwörter

Stichwörter der Autor:innen

giant magnetoresistancelow-frequency noiselow-noise amplifiers

Autor:innen und Institutionen

  • Applied Electronics Department, Technical University of Cluj-Napoca, 400114 Cluj-Napoca, Romania.
  • Centre for Superconductivity, Spintronics and Surface Science, Technical University of Cluj-Napoca, 400114 Cluj-Napoca, Romania.
  • European University of Technology, European Union.
  • Physics and Chemistry Department, Technical University of Cluj-Napoca, 400114 Cluj-Napoca, Romania.
  • EUt+ Institute of Nanomaterials & Nanotechnologies-EUTINN, European University of Technology, European Union.

ORCID-Profile: Liviu Marin Viman, Ovidiu Aurel Pop

Förderung

  • Unitatea Executiva Pentru Finantarea Invatamantului Superior a Cercetarii Dezvoltarii si Inovarii
  • MRID-CNCS-UEFISCDI
  • PNCDI IV

Zitieren

APA

Davidaș, C., Ștețco, E. M., Viman, L. M., Gabor, M. S., Pop, O. A., & Petrișor, T. (2025). Electronic Noise Measurement of a Magnetoresistive Sensor: A Comparative Study. Sensors, 25(19), 6182. https://doi.org/10.3390/s25196182

Vancouver

Davidaș C, Ștețco EM, Viman LM, Gabor MS, Pop OA, Petrișor T. Electronic Noise Measurement of a Magnetoresistive Sensor: A Comparative Study. Sensors. 2025;25(19):6182. doi:10.3390/s25196182

BibTeX
@article{Davida2025,
  author = {Davidaș, Cristina and Ștețco, Elena Mirela and Viman, Liviu Marin and Gabor, Mihai Sebastian and Pop, Ovidiu Aurel and Petrișor, Traian},
  title = {Electronic Noise Measurement of a Magnetoresistive Sensor: A Comparative Study},
  journal = {Sensors},
  year = {2025},
  volume = {25},
  number = {19},
  pages = {6182},
  doi = {10.3390/s25196182}
}
Kostenlos starten →