EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Using the Injection System as a Sensor to Analyze the State of the Electronic Automotive System

Matej Kucera iD, Miroslav Gutten iD, Daniel Korenciak iD, Michal Prazenica iD, Tomasz N Koltunowicz iD

Sensors · 18.09.2025 · 25 (18) · 5814

DOI: 10.3390/s25185814 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 18.09.2025. Verfasst von Matej Kucera und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Mechatronics and Electronics, Faculty of Electrical Engineering and Information Technology, University of Zilina, Univerzitna 1, 01026 …. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 19 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Slovak Research and Development Agency.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper presents a novel diagnostic method that employs the fuel injection system as a sensor for monitoring internal combustion engine pressure, analysing series resistance to detect connector degradation, and evaluating needle movement within the injector’s magnetic core. Experimental results showed that reducing the injector needle opening from 100% to 20% of its maximum displacement caused up to a 35% reduction in peak current amplitude and a 0.2 ms delay in coil charging. Increasing fuel pressure from 0.3 bar to 2.5 bar resulted in a rise in peak current by approximately 35% and an extension of coil charging delay by 0.4 ms. Furthermore, increasing the series resistance from 0.2 Ω to 2.0 Ω reduced the current amplitude by nearly 50% and significantly distorted the waveform, simulating connector oxidation or wear. Comparative analysis of reference and fault current waveforms confirmed that variations in electrical parameters correlate with injector needle displacement, fuel pressure, and resistance changes. Finally, an automated diagnostic system was developed that achieved over 90% accuracy in independently detecting injector faults based on current waveform characteristics.

Schlagwörter

Stichwörter der Autor:innen

diagnostic systemdiagnosticsinjection systempressureseries resistance

Autor:innen und Institutionen

  • Department of Mechatronics and Electronics, Faculty of Electrical Engineering and Information Technology, University of Zilina, Univerzitna 1, 01026 Zilina, Slovakia.
  • Department of Electrical Apparatus and High Voltages Technology, Lublin University of Technology, 20-618 Lublin, Poland.

ORCID-Profile: Matej Kucera, Miroslav Gutten, Daniel Korenciak, Michal Prazenica, Tomasz N Koltunowicz

Förderung

  • Slovak Research and Development Agency

Zitieren

APA

Kucera, M., Gutten, M., Korenciak, D., Prazenica, M., & Koltunowicz, T. N. (2025). Using the Injection System as a Sensor to Analyze the State of the Electronic Automotive System. Sensors, 25(18), 5814. https://doi.org/10.3390/s25185814

Vancouver

Kucera M, Gutten M, Korenciak D, Prazenica M, Koltunowicz TN. Using the Injection System as a Sensor to Analyze the State of the Electronic Automotive System. Sensors. 2025;25(18):5814. doi:10.3390/s25185814

BibTeX
@article{Kucera2025,
  author = {Kucera, Matej and Gutten, Miroslav and Korenciak, Daniel and Prazenica, Michal and Koltunowicz, Tomasz N},
  title = {Using the Injection System as a Sensor to Analyze the State of the Electronic Automotive System},
  journal = {Sensors},
  year = {2025},
  volume = {25},
  number = {18},
  pages = {5814},
  doi = {10.3390/s25185814}
}
Kostenlos starten →