EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Feasibility Study on Additive Manufacturing of Feed Horn Operating in D-Band

Giuseppe Addamo iD, Lorenzo Scalcinati iD, Mario Zannoni iD, Oscar Antonio Peverini, Flaviana Calignano iD

Sensors · 17.01.2025 · 25 (2) · 523

DOI: 10.3390/s25020523 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 17.01.2025. Verfasst von Giuseppe Addamo und 4 weiteren Autor:innen. Beteiligte Einrichtung: Consiglio Nazionale delle Ricerche, IEIIT, Corso Duca degli Abruzzi 24, 10129 Torino, Italy. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper presents the outcomes of a feasibility study on the manufacturing of D-band horn antennas through the Low Power Bed Fusion process. Different prototypes have been realized and tested, showing nice results in terms of the co-polarization component. On the other hand, a spurious cross-polarization component is present in the radiation pattern even in the principal planes, limiting the device to single-polarization applications. A mechanical study of the realized devices has been conducted on the horn internal channel to understand the reasons for this issue, and, subsequently, to address where to improve the manufacturing process.

Schlagwörter

Stichwörter der Autor:innen

D-bandPBF-LB/Madditive manufacturingsmooth wall horn

Autor:innen und Institutionen

  • Consiglio Nazionale delle Ricerche, IEIIT, Corso Duca degli Abruzzi 24, 10129 Torino, Italy.
  • Physics Department, University of Milano Bicocca, Piazza della Scienza 3, 20126 Milano, Italy.
  • Department of Management and Production Engineering (DIGEP), Politecnico di Torino, Corso Duca degli Abruzzi 24, 10129 Torino, Italy.

ORCID-Profile: Giuseppe Addamo, Lorenzo Scalcinati, Mario Zannoni, Flaviana Calignano

Zitieren

APA

Addamo, G., Scalcinati, L., Zannoni, M., Peverini, O. A., & Calignano, F. (2025). Feasibility Study on Additive Manufacturing of Feed Horn Operating in D-Band. Sensors, 25(2), 523. https://doi.org/10.3390/s25020523

Vancouver

Addamo G, Scalcinati L, Zannoni M, Peverini OA, Calignano F. Feasibility Study on Additive Manufacturing of Feed Horn Operating in D-Band. Sensors. 2025;25(2):523. doi:10.3390/s25020523

BibTeX
@article{Addamo2025,
  author = {Addamo, Giuseppe and Scalcinati, Lorenzo and Zannoni, Mario and Peverini, Oscar Antonio and Calignano, Flaviana},
  title = {Feasibility Study on Additive Manufacturing of Feed Horn Operating in D-Band},
  journal = {Sensors},
  year = {2025},
  volume = {25},
  number = {2},
  pages = {523},
  doi = {10.3390/s25020523}
}
Kostenlos starten →