EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

An Over-Actuated Hexacopter Tilt-Rotor UAV Prototype for Agriculture of Precision: Modeling and Control

Gabriel Oliveira Pimentel iD, Murillo Ferreira Dos Santos iD, José Lima iD, Paolo Mercorelli iD, Fernanda Mara Fernandes

Sensors · 15.01.2025 · 25 (2) · 479

DOI: 10.3390/s25020479 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 15.01.2025. Verfasst von Gabriel Oliveira Pimentel und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Electroelectronics, Federal Center of Technological Education of Minas Gerais (CEFET-MG), Leopoldina 36700-001, Brazil. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 61 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: FCT/MCTES (PIDDAC), SusTEC, the National Council for Scientific and Technological Development - CNPq.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper focuses on the modeling, control, and simulation of an over-actuated hexacopter tilt-rotor (HTR). This configuration implies that two of the six actuators are independently tilted using servomotors, which provide high maneuverability and reliability. This approach is predicted to maintain zero pitch throughout the trajectory and is expected to improve the aircraft’s steering accuracy. This arrangement is particularly beneficial for precision agriculture (PA) applications where accurate monitoring and management of crops are critical. The enhanced maneuverability allows for precise navigation in complex vineyard environments, enabling the unmanned aerial vehicle (UAV) to perform tasks such as aerial imaging and crop health monitoring. The employed control architecture consists of cascaded proportional (P)-proportional, integral and derivative (PID) controllers using the successive loop closure (SLC) method on the five controlled degrees of freedom (DoFs). Simulated results using Gazebo demonstrate that the HTR achieves stability and maneuverability throughout the flight path, significantly improving precision agriculture practices. Furthermore, a comparison of the HTR with a traditional hexacopter validates the proposed approach.

Schlagwörter

Stichwörter der Autor:innen

hexacopterover-actuated UAVtilt-rotor

Autor:innen und Institutionen

  • Department of Electroelectronics, Federal Center of Technological Education of Minas Gerais (CEFET-MG), Leopoldina 36700-001, Brazil.
  • Research Centre in Digitalization and Intelligent Robotics (CeDRI), Sustainability and Technology in Mountain Regions (SusTEC), Instituto Politécnico de Bragança (IPB), 5300-253 Bragança, Portugal.
  • Institute for Production Technology and Systems (IPTS), Leuphana Universität Lüneburg, 21335 Lüneburg, Germany.
  • Faculty of Minas Gerais (FAMINAS), Muriaé 36888-233, Brazil.

ORCID-Profile: Gabriel Oliveira Pimentel, Murillo Ferreira Dos Santos, José Lima, Paolo Mercorelli

Förderung

  • FCT/MCTES (PIDDAC)
  • SusTEC
  • the National Council for Scientific and Technological Development - CNPq
  • National Council for Scientific and Technological Development—CNPq

Zitieren

APA

Pimentel, G. O., Santos, M. F. D., Lima, J., Mercorelli, P., & Fernandes, F. M. (2025). An Over-Actuated Hexacopter Tilt-Rotor UAV Prototype for Agriculture of Precision: Modeling and Control. Sensors, 25(2), 479. https://doi.org/10.3390/s25020479

Vancouver

Pimentel GO, Santos MFD, Lima J, Mercorelli P, Fernandes FM. An Over-Actuated Hexacopter Tilt-Rotor UAV Prototype for Agriculture of Precision: Modeling and Control. Sensors. 2025;25(2):479. doi:10.3390/s25020479

BibTeX
@article{Pimentel2025,
  author = {Pimentel, Gabriel Oliveira and Santos, Murillo Ferreira Dos and Lima, José and Mercorelli, Paolo and Fernandes, Fernanda Mara},
  title = {An Over-Actuated Hexacopter Tilt-Rotor UAV Prototype for Agriculture of Precision: Modeling and Control},
  journal = {Sensors},
  year = {2025},
  volume = {25},
  number = {2},
  pages = {479},
  doi = {10.3390/s25020479}
}
Kostenlos starten →