Online Calibration of Inertial Sensors Based on Error Backpropagation
Sensors · 25.11.2024 · 24 (23) · 7525
DOI: 10.3390/s24237525 ↗Kurz gefasst
Fachartikel in der Zeitschrift Sensors, online erschienen am 25.11.2024. Verfasst von Vojtech Simak und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Control and Information Systems, Faculty of Electrical Engineering and Information Technology, University of Žilina, 010 26 Žilina, Slo…. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Slovak Research and Development Agency, Advanced Localization Sensors and Techniques for Autonomous Vehicles and Robots.
Abstract (Originalsprache)
Global satellite navigation systems (GNSSs) are the most-used technology for the localization of vehicles in the outdoor environment, but in the case of a densely built-up area or during passage through a tunnel, the satellite signal is not available or has poor quality. Inertial navigation systems (INSs) allow localization dead reckoning, but they have an integration error that grows over time. Inexpensive inertial measurement units (IMUs) are subject to thermal-dependent error and must be calibrated almost continuously. This article proposes a novel method of online (continuous) calibration of inertial sensors with the aid of the data from the GNSS receiver during the vehicle’s route. We performed data fusion using an extended Kalman filter (EKF) and calibrated the input sensors through error backpropagation. The algorithm thus calibrates the INS sensors while the GNSS receiver signal is good, and after a GNSS failure, for example in tunnels, the position is predicted only by low-cost inertial sensors. Such an approach significantly improved the localization precision in comparison with offline calibrated inertial localization with the same sensors.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Control and Information Systems, Faculty of Electrical Engineering and Information Technology, University of Žilina, 010 26 Žilina, Slovakia.
ORCID-Profile: Vojtech Simak, Jan Andel, Dusan Nemec, Juraj Kekelak
Förderung
- Slovak Research and Development Agency
- Advanced Localization Sensors and Techniques for Autonomous Vehicles and Robots
Zitieren
APA
Simak, V., Andel, J., Nemec, D., & Kekelak, J. (2024). Online Calibration of Inertial Sensors Based on Error Backpropagation. Sensors, 24(23), 7525. https://doi.org/10.3390/s24237525
Vancouver
Simak V, Andel J, Nemec D, Kekelak J. Online Calibration of Inertial Sensors Based on Error Backpropagation. Sensors. 2024;24(23):7525. doi:10.3390/s24237525
BibTeX
@article{Simak2024,
author = {Simak, Vojtech and Andel, Jan and Nemec, Dusan and Kekelak, Juraj},
title = {Online Calibration of Inertial Sensors Based on Error Backpropagation},
journal = {Sensors},
year = {2024},
volume = {24},
number = {23},
pages = {7525},
doi = {10.3390/s24237525}
}
EUVIMED