EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Automated Imaging to Evaluate the Exogenous Gibberellin (Ga3) Impact on Seedlings from Salt-Stressed Lettuce Seeds

Mark Iradukunda, Marc W van Iersel iD, Lynne Seymour iD, Guoyu Lu, Rhuanito Soranz Ferrarezi iD

Sensors · 2024

DOI: 10.3390/s24134228 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, 2024. Verfasst von Mark Iradukunda und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Horticulture, University of Georgia, Athens, GA 30602, USA. Hauptthemen laut MEDLINE: Gibberellins, Lactuca, Seedlings, Germination. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: American Floral Endowment, Horticultural Research Institute, College of Agricultural and Environmental Sciences.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Salinity stress is a common challenge in plant growth, impacting seed quality, germination, and general plant health. Sodium chloride (NaCl) ions disrupt membranes, causing ion leakage and reducing seed viability. Gibberellic acid (GA3) treatments have been found to promote germination and mitigate salinity stress on germination and plant growth. ‘Bauer’ and ‘Muir’ lettuce (Lactuca sativa) seeds were soaked in distilled water (control), 100 mM NaCl, 100 mM NaCl + 50 mg/L GA3, and 100 mM NaCl + 150 mg/L GA3 in Petri dishes and kept in a dark growth chamber at 25 °C for 24 h. After germination, seedlings were monitored using embedded cameras, capturing red, green, and blue (RGB) images from seeding to final harvest. Despite consistent germination rates, ‘Bauer’ seeds treated with NaCl showed reduced germination. Surprisingly, the ‘Muir’ cultivar’s final dry weight differed across treatments, with the NaCl and high GA3 concentration combination yielding the poorest results (p < 0.05). This study highlights the efficacy of GA3 applications in improving germination rates. However, at elevated concentrations, it induced excessive hypocotyl elongation and pale seedlings, posing challenges for two-dimensional imaging. Nonetheless, a sigmoidal regression model using projected canopy size accurately predicted dry weight across growth stages and cultivars, emphasizing its reliability despite treatment variations (R2 = 0.96, RMSE = 0.11, p < 0.001).

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

GibberellinsLactucaSeedlingsGerminationSeedsSalt StressSodium Chloride

Stichwörter der Autor:innen

Lactuca sativacanopy sizecrop modelinggerminationimage analysissalinity

Substanzen

Gibberellinsgibberellic acidSodium Chloride

Autor:innen und Institutionen

  • Department of Horticulture, University of Georgia, Athens, GA 30602, USA.
  • Department of Statistics, University of Georgia, Athens, GA 30602, USA.
  • College of Engineering, University of Georgia, Athens, GA 30602, USA.

ORCID-Profile: Marc W van Iersel, Lynne Seymour, Rhuanito Soranz Ferrarezi

Förderung

  • American Floral Endowment
  • Horticultural Research Institute
  • College of Agricultural and Environmental Sciences
  • Office of the Senior Vice President for Academic Affairs and Provost
  • USDA-NIFA-SCRI
  • LAMP: Lighting Approaches to Maximize Profits
  • Department of Horticulture

Zitieren

APA

Iradukunda, M., van Iersel, M. W., Seymour, L., Lu, G., & Ferrarezi, R. S. (2024). Automated Imaging to Evaluate the Exogenous Gibberellin (Ga3) Impact on Seedlings from Salt-Stressed Lettuce Seeds. Sensors. https://doi.org/10.3390/s24134228

Vancouver

Iradukunda M, van Iersel MW, Seymour L, Lu G, Ferrarezi RS. Automated Imaging to Evaluate the Exogenous Gibberellin (Ga3) Impact on Seedlings from Salt-Stressed Lettuce Seeds. Sensors. 2024. doi:10.3390/s24134228

BibTeX
@article{Iradukunda2024,
  author = {Iradukunda, Mark and van Iersel, Marc W and Seymour, Lynne and Lu, Guoyu and Ferrarezi, Rhuanito Soranz},
  title = {Automated Imaging to Evaluate the Exogenous Gibberellin (Ga3) Impact on Seedlings from Salt-Stressed Lettuce Seeds},
  journal = {Sensors},
  year = {2024},
  doi = {10.3390/s24134228}
}
Kostenlos starten →