EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Development of 2400–2450 MHz Frequency Band RF Energy Harvesting System for Low-Power Device Operation

Nasir Ullah Khan iD, Sana Ullah, Farid Ullah Khan iD, Arcangelo Merla

Sensors · 08.05.2024 · 24 (10) · 2986

DOI: 10.3390/s24102986 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, online erschienen am 08.05.2024. Verfasst von Nasir Ullah Khan und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Engineering and Geology, Università degli Studi "G. d'Annunzio" Chieti-Pescara, 65127 Pescara, Italy. Die Arbeit wurde bisher 12-mal zitiert (Crossref) und nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Recently, there has been an increasing fascination for employing radio frequency (RF) energy harvesting techniques to energize various low-power devices by harnessing the ambient RF energy in the surroundings. This work outlines a novel advancement in RF energy harvesting (RFEH) technology, intending to power portable gadgets with minimal operating power demands. A high-gain receiver microstrip patch antenna was designed and tested to capture ambient RF residue, operating at 2450 MHz. Similarly, a two-stage Dickson voltage booster was developed and employed with the RFEH to transform the received RF signals into useful DC voltage signals. Additionally, an LC series circuit was utilized to ensure impedance matching between the antenna and rectifier, facilitating the extraction of maximum power from the developed prototype. The findings indicate that the developed rectifier attained a peak power conversion efficiency (PCE) of 64% when operating at an input power level of 0 dBm. During experimentation, the voltage booster demonstrated its capability to rectify a minimum input AC signal of only 50 mV, yielding a corresponding 180 mV output DC signal. Moreover, the maximum power of 4.60 µW was achieved when subjected to an input AC signal of 1500 mV with a load resistance of 470 kΩ. Finally, the devised RFEH was also tested in an open environment, receiving signals from Wi-Fi modems positioned at varying distances for evaluation.

Schlagwörter

Stichwörter der Autor:innen

energy harvestingimpedance matchingpatch antennaradio frequencyrectifier circuit

Autor:innen und Institutionen

  • Department of Engineering and Geology, Università degli Studi "G. d'Annunzio" Chieti-Pescara, 65127 Pescara, Italy.
  • Department of Electrical and Information Engineering, Politecnico di Bari, 70126 Bari, Italy.
  • Department of Mechatronics Engineering, University of Engineering and Technology, Peshawar 25000, Pakistan.

ORCID-Profile: Nasir Ullah Khan, Farid Ullah Khan

Zitieren

APA

Khan, N. U., Ullah, S., Khan, F. U., & Merla, A. (2024). Development of 2400–2450 MHz Frequency Band RF Energy Harvesting System for Low-Power Device Operation. Sensors, 24(10), 2986. https://doi.org/10.3390/s24102986

Vancouver

Khan NU, Ullah S, Khan FU, Merla A. Development of 2400–2450 MHz Frequency Band RF Energy Harvesting System for Low-Power Device Operation. Sensors. 2024;24(10):2986. doi:10.3390/s24102986

BibTeX
@article{Khan2024,
  author = {Khan, Nasir Ullah and Ullah, Sana and Khan, Farid Ullah and Merla, Arcangelo},
  title = {Development of 2400–2450 MHz Frequency Band RF Energy Harvesting System for Low-Power Device Operation},
  journal = {Sensors},
  year = {2024},
  volume = {24},
  number = {10},
  pages = {2986},
  doi = {10.3390/s24102986}
}
Kostenlos starten →