EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Development of DMPS-EMAT for Long-Distance Monitoring of Broken Rail

Wujun Guo iD, Zhiyang Yu, Hsiang-Chen Chui iD, Xiaoming Chen iD

Sensors · 2023

DOI: 10.3390/s23125583 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, 2023. Verfasst von Wujun Guo und 3 weiteren Autor:innen. Beteiligte Einrichtung: School of Optoelectronic Engineering and Instrumentation Science, Dalian University of Technology, Dalian 116000, China. Hauptthemen laut MEDLINE: Magnets, Technology. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 34 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National key research and development program, National Key Research and Development Program of China, Wuhan Railway Bureau R&D Project.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The safety of railway transportation is crucial to social and economic development. Therefore, real-time monitoring of the rail is particularly necessary. The current track circuit structure is complex and costly, posing challenges to monitoring broken tracks using alternative methods. As a non-contact detection technology with a lower environmental impact, electromagnetic ultrasonic transducers (EMATs) have become a concern. However, traditional EMATs have problems such as low conversion efficiency and complex modes, which can limit their effectiveness for long-distance monitoring. Therefore, this study introduces a novel dual-magnet phase-stacked EMAT (DMPS-EMAT) design comprising two magnets and a dual-layer winding coil arrangement. The magnets are positioned at a distance equal to the wavelength of the A0 wave from each other, while the center distance between the two sets of coils beneath the transducer is also equal to the wavelength. After analyzing the dispersion curves of the rail waist, it was determined that the optimal frequency for long-distance rail monitoring is 35 kHz. At this frequency, adjusting the relative positions of the two magnets and the coil directly underneath to be one A0 wavelength can effectively excite a constructive interference A0 wave in the rail waist. The simulation and experimental results show that DMPS-EMAT excited a single-mode A0 wave, resulting in a 1.35-times increase in amplitude.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

MagnetsTechnologyComputer SimulationTransducersTransportation

Stichwörter der Autor:innen

EMATconstructive interferencesignal enhancementsingle-mode A0 wave

Autor:innen und Institutionen

  • School of Optoelectronic Engineering and Instrumentation Science, Dalian University of Technology, Dalian 116000, China.
  • Signal & Communication Research Institute, China Academy of Railway Sciences Corporation Limited, Beijing 100081, China.

ORCID-Profile: Wujun Guo, Hsiang-Chen Chui, Xiaoming Chen

Förderung

  • National key research and development program
  • National Key Research and Development Program of China
  • Wuhan Railway Bureau R&D Project

Zitieren

APA

Guo, W., Yu, Z., Chui, H. C., & Chen, X. (2023). Development of DMPS-EMAT for Long-Distance Monitoring of Broken Rail. Sensors. https://doi.org/10.3390/s23125583

Vancouver

Guo W, Yu Z, Chui HC, Chen X. Development of DMPS-EMAT for Long-Distance Monitoring of Broken Rail. Sensors. 2023. doi:10.3390/s23125583

BibTeX
@article{Guo2023,
  author = {Guo, Wujun and Yu, Zhiyang and Chui, Hsiang-Chen and Chen, Xiaoming},
  title = {Development of DMPS-EMAT for Long-Distance Monitoring of Broken Rail},
  journal = {Sensors},
  year = {2023},
  doi = {10.3390/s23125583}
}
Kostenlos starten →