EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

A Study on the Underwater Energy Harvester with Two PVDFs Installed on the FTEH and CTEH at the End of the Support

Jongkil Lee, Jinhyo An, Chonghyun Lee, Yoonsang Jeong, Hee-Seon Seo, Yohan Cho

Sensors · 2023

DOI: 10.3390/s23020808 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sensors, 2023. Verfasst von Jongkil Lee und 5 weiteren Autor:innen. Beteiligte Einrichtung: Mechanical Engineering Education, Andong National University, Andong 36729, Republic of Korea. Hauptthemen laut MEDLINE: Electricity. Die Arbeit nennt 13 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Defense Acquisition Program Administration.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this study, two thin rectangular PVDFs were installed in the form of a cantilever on a FTEH (funnel-type energy harvester), and a CTEH (cymbal-type energy harvester) was fabricated in a form coupled to the upper part of the support. As a result of measuring the energy harvesting sensitivity according to the installation direction of the CTEH, a high voltage was measured in the structure installed on top of the support across all flow velocity conditions. A composite structure PVDF energy harvester combining CTEH and FTEH was fabricated and the amount of power generated was measured. As a result of measuring the open-circuit voltage of the PVDF energy harvester device with a composite structure to which the optimum resistance of CTEH of 241 kΩ and the optimum resistance of FTEH of 1474 kΩ were applied at a flow rate of 0.25 m/s, the output voltage compared to the RMS average value was 7 to 8.5 times higher for FTEH than for CTEH. When the flow rate was 0.5 m/s, the electrical energy charged for 500 s was measured as 2.0 μWs to 2.5 μWs, and when the flow speed was 0.75 m/s, it reached 2.5 μWs when charged for 300 s, generating the same amount when the flow rate increased by 50%. The time to do it was reduced by 66.7%.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

ElectricityPhysical PhenomenaFluorocarbon PolymersPolyvinyls

Stichwörter der Autor:innen

cantilever type PVDFcymbal-type energy harvesterfunnel-type energy harvestervoltage doubler rectifiervortex-induced vibration

Substanzen

polyvinylidene fluorideFluorocarbon PolymersPolyvinyls

Autor:innen und Institutionen

  • Mechanical Engineering Education, Andong National University, Andong 36729, Republic of Korea.
  • Ocean System Engineering, Cheju National University, Jeju 63243, Republic of Korea.
  • Agency for Defense Development, Changwon 51682, Republic of Korea.

Förderung

  • Defense Acquisition Program Administration

Zitieren

APA

Lee, J., An, J., Lee, C., Jeong, Y., Seo, H. S., & Cho, Y. (2023). A Study on the Underwater Energy Harvester with Two PVDFs Installed on the FTEH and CTEH at the End of the Support. Sensors. https://doi.org/10.3390/s23020808

Vancouver

Lee J, An J, Lee C, Jeong Y, Seo HS, Cho Y. A Study on the Underwater Energy Harvester with Two PVDFs Installed on the FTEH and CTEH at the End of the Support. Sensors. 2023. doi:10.3390/s23020808

BibTeX
@article{Lee2023,
  author = {Lee, Jongkil and An, Jinhyo and Lee, Chonghyun and Jeong, Yoonsang and Seo, Hee-Seon and Cho, Yohan},
  title = {A Study on the Underwater Energy Harvester with Two PVDFs Installed on the FTEH and CTEH at the End of the Support},
  journal = {Sensors},
  year = {2023},
  doi = {10.3390/s23020808}
}
Kostenlos starten →