Ultrasonic Oxidative Treatment of Per- and Polyfluoroalkyl Substances (PFAS) in Aqueous Film-Forming Foams and Foam-Derived Wastewaters
Processes · 18.11.2026 · 14 (22) · 3707
DOI: 10.3390/pr14223707 ↗Kurz gefasst
Fachartikel in der Zeitschrift Processes, online erschienen am 18.11.2026. Verfasst von Olalekan Simon Awoyemi und 3 weiteren Autor:innen. Die Arbeit nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Australian Research Council, CRC for Contamination Assessment and Remediation of the Environment, University of Newcastle, Australia.
Abstract (Originalsprache)
Ultrasonication has attracted interest as a potential approach for treating per- and polyfluoroalkyl substances (PFAS), with oxidant addition proposed to enhance treatment performance. However, whether oxidant addition consistently improves PFAS degradation across different PFAS compounds and complex waste matrices remains insufficiently understood. This study’s distinctive contribution is a comparative evaluation of oxidant-assisted ultrasonication across individual PFAS compounds and real PFAS-containing waste matrices, providing evidence of how oxidant selection, PFAS molecular structure, and matrix composition jointly influence treatment outcomes. Hydrogen peroxide (H2O2), sodium persulfate (Na2S2O8), and ferric chloride (FeCl3) were evaluated under fixed-mass-dose ultrasonic conditions using PFOA and PFOS model solutions, aqueous film-forming foam (AFFF), and foam fractionate (FF). Ultrasonication was conducted at 580 kHz and 187.5 W for 3 h. In model solutions, H2O2 and Na2S2O8 produced only marginal improvements in PFOA degradation compared with ultrasonication alone (76%), whereas PFOS degradation decreased from 59% without oxidant addition to 43–45% with oxidants. The corresponding apparent pseudo-first-order rate constants for PFOA increased slightly from 8.2 × 10−3 min–1 under ultrasonication alone to 8.9 × 10–3 and 8.7 × 10–3 min–1 with H2O2 and Na2S2O8, respectively. In contrast, the rate constants for PFOS decreased from 5.2 × 10–3 min–1 to 3.1 × 10–3 and 3.3 × 10–3 min–1, respectively. FeCl3 also substantially reduced PFOA defluorination. In the real waste matrices, PFAS degradation ranged from 37 to 63% in AFFF and 75 to 81% in FF, with oxidant addition providing no consistent improvement over ultrasonication alone. The contrasting responses across model solutions and real matrices demonstrate that oxidant-assisted ultrasonication does not produce universally beneficial effects and that treatment performance cannot be reliably predicted from individual PFAS solutions alone. These findings highlight the limitations of oxidant-assisted ultrasonication and the need to account for oxidant selection, PFAS molecular structure, and matrix composition when evaluating its application to real waste streams. The study provides a comparative assessment of three oxidants (hydrogen peroxide, H2O2; sodium persulfate, Na2S2O8; and ferric chloride, FeCl3) under fixed-mass-dose ultrasonic conditions, extending the investigation from individual PFAS compounds to real foam-derived waste matrices to examine the influence of PFAS structure and matrix composition on treatment performance. Experiments were conducted using a 1 L batch reactor operated at 580 kHz and 187.5 W. H2O2, Na2S2O8, and FeCl3 were screened at applied mass concentrations to assess their effects under the investigated ultrasonic conditions. An optimum Na2S2O8 concentration of 0.1 g/L yielded 62% PFOA defluorination, while H2O2 achieved 63%; FeCl3 strongly inhibited the process (26%). PFOA degradation followed apparent pseudo-first-order kinetics, with ultrasonication alone achieving 76% degradation and oxidant addition producing only marginal improvements (79–80%). In contrast, PFOS degradation was lower (59%) and decreased to 43–45% in the presence of oxidants. Analysis of degradation products revealed sequential chain-shortening for PFOA and concurrent desulfonation and sulfonate-retaining pathways for PFOS. For real PFAS wastes, ultrasonication alone achieved 40% and 46% defluorination for AFFF and FF, respectively, while oxidants provided little benefit. PFAS degradation ranged from 37 to 63% for AFFF and 75–81% for FF, with persulfate reducing treatment performance. Overall, the results demonstrate that the effects of oxidant-assisted ultrasonication depend on oxidant type, PFAS molecular structure, and matrix composition, with these factors jointly influencing treatment performance under the investigated conditions. The limited benefits in real wastes highlight the importance of matrix-aware strategies for PFAS remediation.
Förderung
- Australian Research Council
- CRC for Contamination Assessment and Remediation of the Environment
- University of Newcastle, Australia
Zitieren
APA
Awoyemi, O. S., Egbuatu, M., Adeleye, A. T., & Naidu, R. (2026). Ultrasonic Oxidative Treatment of Per- and Polyfluoroalkyl Substances (PFAS) in Aqueous Film-Forming Foams and Foam-Derived Wastewaters. Processes, 14(22), 3707. https://doi.org/10.3390/pr14223707
Vancouver
Awoyemi OS, Egbuatu M, Adeleye AT, Naidu R. Ultrasonic Oxidative Treatment of Per- and Polyfluoroalkyl Substances (PFAS) in Aqueous Film-Forming Foams and Foam-Derived Wastewaters. Processes. 2026;14(22):3707. doi:10.3390/pr14223707
BibTeX
@article{Awoyemi2026,
author = {Awoyemi, Olalekan Simon and Egbuatu, Maureen and Adeleye, Aderemi Timothy and Naidu, Ravi},
title = {Ultrasonic Oxidative Treatment of Per- and Polyfluoroalkyl Substances (PFAS) in Aqueous Film-Forming Foams and Foam-Derived Wastewaters},
journal = {Processes},
year = {2026},
volume = {14},
number = {22},
pages = {3707},
doi = {10.3390/pr14223707}
}
EUVIMED