Study on the Structural Design and Dynamic Performance of a Bottom-Hole Self-Renewal PDC Drill Bit
Processes · 05.11.2026 · 14 (21) · 3569
DOI: 10.3390/pr14213569 ↗Kurz gefasst
Fachartikel in der Zeitschrift Processes, online erschienen am 05.11.2026. Verfasst von Xiaoao Liu und 6 weiteren Autor:innen. Die Arbeit nennt 27 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Complex deep underground safe and efficient drilling and completion technology and equipment, Synthesis of composite sheets of ultra-high pressure and superhard materials, upgrading of drill bit technology, and on-site testing, Nanchong City–Southwest Petroleum University City-School Science and Technology Strategic Cooperation Project.
Abstract (Originalsprache)
Progressive wear of the cutting structure degrades the performance of polycrystalline diamond compact (PDC) drill bits during deep and ultradeep drilling. Current designs primarily delay wear through improved material wear resistance and structural optimization, but provide limited capability for active downhole restoration after wear. This study proposes a rotary self-renewing PDC drill bit driven by drilling-fluid pressure through a worm gear transmission. The design allows active renewal of the cutting structure downhole. The overall bit structure was developed around four modules for pressure actuation, motion conversion and transmission, cutting-structure renewal, and position limiting. Kinematic and dynamic models were established to assess the required driving force and transmission characteristics. Computational fluid dynamics (CFD) simulations were used to evaluate the effect of piston clearance on pressure transmission, and Adams simulations were used to examine the motion and dynamic response of the mechanism. The total resisting torque of the renewal modules, including transmission resistance, was 3.84 N·m, corresponding to a theoretical driving force of approximately 115 N. In the Adams simulation, the renewal modules began moving at 120 N, a deviation of 4.3% from the theoretical value. A proof-of-concept prototype was then tested to verify the renewal function. At a water pressure of 0.8 MPa, the piston traveled 67 mm and rotated the renewal modules by approximately 114°, achieving one cutting-structure renewal. The results indicate that the proposed mechanism can use drilling-fluid pressure to achieve stable adjustment of the cutting structure. This design provides a structural approach to active downhole renewal of worn PDC cutting structures.
Förderung
- Complex deep underground safe and efficient drilling and completion technology and equipment
- Synthesis of composite sheets of ultra-high pressure and superhard materials, upgrading of drill bit technology, and on-site testing
- Nanchong City–Southwest Petroleum University City-School Science and Technology Strategic Cooperation Project
- Deep Earth Probe and Mineral Resources Exploration–National Science and Technology Major Project
Zitieren
APA
Liu, X., Wu, Q., Huang, K., Wu, X., Yu, J., Ji, G., & Ren, H. (2026). Study on the Structural Design and Dynamic Performance of a Bottom-Hole Self-Renewal PDC Drill Bit. Processes, 14(21), 3569. https://doi.org/10.3390/pr14213569
Vancouver
Liu X, Wu Q, Huang K, Wu X, Yu J, Ji G, et al. Study on the Structural Design and Dynamic Performance of a Bottom-Hole Self-Renewal PDC Drill Bit. Processes. 2026;14(21):3569. doi:10.3390/pr14213569
BibTeX
@article{Liu2026,
author = {Liu, Xiaoao and Wu, Qiang and Huang, Kuilin and Wu, Xinyue and Yu, Jinping and Ji, Guodong and Ren, Haitao},
title = {Study on the Structural Design and Dynamic Performance of a Bottom-Hole Self-Renewal PDC Drill Bit},
journal = {Processes},
year = {2026},
volume = {14},
number = {21},
pages = {3569},
doi = {10.3390/pr14213569}
}
EUVIMED