EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Mechanical Characterization and Artificial Floor Design for Underhand Cut-And-Fill Mining in a Kaolinized Altered Orebody

Yantian Yin, Zhihai An, Weiguo Li, Chao Peng, Shuyan Du, Chengpeng Liu

Processes · 02.07.2026 · 14 (13) · 2157

DOI: 10.3390/pr14132157 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Processes, online erschienen am 02.07.2026. Verfasst von Yantian Yin und 5 weiteren Autor:innen. Die Arbeit nennt 36 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Natural Science Foundation of Shandong Province.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Thin, steeply dipping orebodies hosted in kaolinized altered fault zones are difficult to mine safely because of weak rock mass integrity, water sensitivity, and limited self-supporting capacity. This study investigates the F20 ore-bearing altered structural zone at Changtai Mining and develops an artificial floor design for downward drift-and-fill mining. Engineering geological characterization, rock mass quality evaluation, mechanical analysis, and three-dimensional numerical simulation were combined to assess floor-bearing requirements and regional recovery stability. The results show that the wall rocks are grade III, whereas the ore-bearing altered zone is grade IV and represents the controlling weak component. For the preferred 3.5 m × 3.5 m drift, an equivalent artificial floor bearing thickness of about 1.0 m is required. Numerical evaluation indicates that supported drifts remain stable, but crosscut–drift intersections are the main deformation and damage concentration zones. A representative 0.5 m drift offset significantly weakens the load-transfer path of the floor–rock system. The proposed vertically aligned, short drift, rapid backfill scheme with a reinforced composite artificial floor provides a practical basis for safe recovery of weak kaolinized altered orebodies.

Förderung

  • Natural Science Foundation of Shandong Province

Zitieren

APA

Yin, Y., An, Z., Li, W., Peng, C., Du, S., & Liu, C. (2026). Mechanical Characterization and Artificial Floor Design for Underhand Cut-And-Fill Mining in a Kaolinized Altered Orebody. Processes, 14(13), 2157. https://doi.org/10.3390/pr14132157

Vancouver

Yin Y, An Z, Li W, Peng C, Du S, Liu C. Mechanical Characterization and Artificial Floor Design for Underhand Cut-And-Fill Mining in a Kaolinized Altered Orebody. Processes. 2026;14(13):2157. doi:10.3390/pr14132157

BibTeX
@article{Yin2026,
  author = {Yin, Yantian and An, Zhihai and Li, Weiguo and Peng, Chao and Du, Shuyan and Liu, Chengpeng},
  title = {Mechanical Characterization and Artificial Floor Design for Underhand Cut-And-Fill Mining in a Kaolinized Altered Orebody},
  journal = {Processes},
  year = {2026},
  volume = {14},
  number = {13},
  pages = {2157},
  doi = {10.3390/pr14132157}
}
Kostenlos starten →