EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Impact of Moisture Content and Loading Rate on Kernel Damage and Mechanical Properties of Bread and Feed Wheat Kernels

Zdzisław Kaliniewicz

Processes · 09.06.2026 · 14 (12) · 1868

DOI: 10.3390/pr14121868 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Processes, online erschienen am 09.06.2026. Verfasst von Zdzisław Kaliniewicz. Die Arbeit nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Science and Higher Education of the Republic of Poland.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Compression tests are widely used to characterize cereal kernels, yet the loading rate is often treated as a secondary methodological factor, despite the fact that the ASAE S368.4 procedure recommends a low crosshead speed, whereas industrial size-reduction operations involve much faster and more complex loading conditions. This mismatch limits the direct transfer of laboratory data to milling practice and makes it difficult to compare results obtained under different test settings. The aim of this study was therefore to determine how grain moisture content and loading rate (crosshead speed) affect kernel damage and selected mechanical properties of bread wheat cultivars (Bataja and Tytanika) and feed wheat cultivars classified in the Polish C quality group (Lawina and Sikorka). Before the analyses, kernels were adjusted to five moisture levels: 10%, 12%, 14%, 16%, and 18% on a wet basis (w.b.). Compression tests were conducted at six crosshead speeds: 1, 3, 5, 10, 30, and 50 mm min−1. The conversion ratio of mechanical properties determined relative to 1 mm min−1 and 10% moisture content ranged from 0.46 to 2.59, confirming that both factors markedly changed kernel response. Rupture force generally decreased with increasing moisture content, whereas longitudinal strain, relative strain and rupture energy increased. A distinct decrease in all mechanical parameters was observed at 10 mm min−1, and this effect became more pronounced at higher moisture contents. The results indicate that the loading rate should be reported and controlled in wheat kernel compression tests and should be considered when laboratory measurements are used to support milling optimization. However, the proposed value of 10 mm min−1 should be interpreted as a promising laboratory reference point rather than as a direct industrial operating standard.

Förderung

  • Ministry of Science and Higher Education of the Republic of Poland

Zitieren

APA

Kaliniewicz, Z. (2026). Impact of Moisture Content and Loading Rate on Kernel Damage and Mechanical Properties of Bread and Feed Wheat Kernels. Processes, 14(12), 1868. https://doi.org/10.3390/pr14121868

Vancouver

Kaliniewicz Z. Impact of Moisture Content and Loading Rate on Kernel Damage and Mechanical Properties of Bread and Feed Wheat Kernels. Processes. 2026;14(12):1868. doi:10.3390/pr14121868

BibTeX
@article{Kaliniewicz2026,
  author = {Kaliniewicz, Zdzisław},
  title = {Impact of Moisture Content and Loading Rate on Kernel Damage and Mechanical Properties of Bread and Feed Wheat Kernels},
  journal = {Processes},
  year = {2026},
  volume = {14},
  number = {12},
  pages = {1868},
  doi = {10.3390/pr14121868}
}
Kostenlos starten →