EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Experimental Research on Surfactant Flooding and Design of Integrated Schemes for Energy Storage Fracturing and Production in Tight Sandstone Reservoirs

Yujie Zhang, Zhiyang Pi, Gang Hui, Ruihan Zhang, Feng Ni, Ye Li, Chenqi Ge, Penghu Bao, Yujie Zhang, Xing Yang, Dan Wu, Yunli Lu und 1 weitere

Processes · 13.12.2025 · 13 (12) · 4031

DOI: 10.3390/pr13124031 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Processes, online erschienen am 13.12.2025. Verfasst von Yujie Zhang und 12 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 47 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: State Key Laboratory of Oil and Gas Reservoir Geology and Exploration, Science Foundation of China University of Petroleum, Beijing.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The WieZhou12 oilfield (also known as WZ12 oilfield, the same below) is in urgent need of development using large-scale volumetric fracturing technology since it is a typical complex fault-block oilfield with low porosity, low permeability, and no natural production capacity. To study the fracturing measures with surfactants in offshore oilfields like WZ12, the surfactant fracturing fluid types were experimentally selected based on their effect of decreasing interfacial tension and enhancing matrix wettability. The water cut law and oil displacement efficiency in displacement experiments were also analyzed, according to surfactant type and fluid characteristics. Next, using the numerical simulation software CMG, the study completed the integrated simulation of volumetric fracturing in the “injection–soaking–flowback” process. Finally, some critical parameters were optimized for the block model, including the quantity of injected fluids, the soaking time, and the rate of fluid flowback. The results showed that the most suitable surfactant was 0.5% ammonium lauryl polyether sulfate (ALES), which had a low interfacial tension of 1.7 × 10−2 mN/m, a contact angle of 20.071° with the core, and a 52% oil displacement efficiency. From the simulations, the suggested production parameters for energy storage fracturing are as follows: a daily injection volume of 600 m3/d, a soaking time of 25 days post fracturing, and a fluid production rate of 270 m3/d. The findings of this study establish a significant theoretical foundation for optimizing surfactant type and provide construction advice for the integrated measure of fracturing, well shut-in, and production in offshore oilfields.

Förderung

  • State Key Laboratory of Oil and Gas Reservoir Geology and Exploration
  • Science Foundation of China University of Petroleum, Beijing

Zitieren

APA

Zhang, Y., Pi, Z., Hui, G., Zhang, R., Ni, F., Li, Y., Ge, C., Bao, P., Zhang, Y., Yang, X., Wu, D., Lu, Y., & Gu, F. (2025). Experimental Research on Surfactant Flooding and Design of Integrated Schemes for Energy Storage Fracturing and Production in Tight Sandstone Reservoirs. Processes, 13(12), 4031. https://doi.org/10.3390/pr13124031

Vancouver

Zhang Y, Pi Z, Hui G, Zhang R, Ni F, Li Y, et al. Experimental Research on Surfactant Flooding and Design of Integrated Schemes for Energy Storage Fracturing and Production in Tight Sandstone Reservoirs. Processes. 2025;13(12):4031. doi:10.3390/pr13124031

BibTeX
@article{Zhang2025,
  author = {Zhang, Yujie and Pi, Zhiyang and Hui, Gang and Zhang, Ruihan and Ni, Feng and Li, Ye and Ge, Chenqi and Bao, Penghu and Zhang, Yujie and Yang, Xing and Wu, Dan and Lu, Yunli and Gu, Fei},
  title = {Experimental Research on Surfactant Flooding and Design of Integrated Schemes for Energy Storage Fracturing and Production in Tight Sandstone Reservoirs},
  journal = {Processes},
  year = {2025},
  volume = {13},
  number = {12},
  pages = {4031},
  doi = {10.3390/pr13124031}
}
Kostenlos starten →