Effect of Additive Manufacturing Parameters on PLA, ABS, and PETG Strength
Processes · 27.08.2025 · 13 (9) · 2733
DOI: 10.3390/pr13092733 ↗Kurz gefasst
Fachartikel in der Zeitschrift Processes, online erschienen am 27.08.2025. Verfasst von Sergi Menargues und 5 weiteren Autor:innen. Die Arbeit wurde bisher 24-mal zitiert (Crossref) und nennt 42 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Government of Catalonia Agency for Administration of University and Research Grants.
Abstract (Originalsprache)
Additive manufacturing has emerged as a promising technology to fabricate customized polymer parts, but the mechanical performance of printed components often falls short of bulk material properties. Among the different techniques, fused filament fabrication is the most accessible and widely adopted. However, previous studies addressing its processing parameters have produced fragmented or contradictory conclusions, limiting the ability to establish guidelines for mechanical optimization. This work addresses this gap by systematically investigating the influence of key parameters—extrusion temperature, printing speed, infill type and density, layer height, and number of walls—on the tensile properties of three commonly used thermoplastics: PLA, ABS, and PETG. A total of 495 standardized specimens were produced and tested under controlled conditions. The results demonstrate that increasing infill density and wall number consistently enhances tensile strength, with PLA showing an improvement of 1173 N when infill was raised from 20 to 80%, and PETG doubling its strength from 559 N with one wall to 1207 N with five walls. Layer height also had a positive effect, with PLA rising from 995 N at 0.10 mm to 1355 N at 0.30 mm. In contrast, higher printing speeds reduced mechanical performance (PLA decreased by 13% between 20 and 50 mm·s−1). Temperature exhibited material-dependent trends: PLA benefited up to 230 °C (+17%), while ABS strength decreased beyond 220 °C. Overall, the study provides a quantitative assessment of how processing parameters control mechanical reliability in polymer parts, offering practical guidelines for improved design and manufacturing.
Förderung
- Government of Catalonia Agency for Administration of University and Research Grants
Zitieren
APA
Menargues, S., Navas, J., Espinosa, I., Baile, M. T., Vaz, R. F., & Picas, J. A. (2025). Effect of Additive Manufacturing Parameters on PLA, ABS, and PETG Strength. Processes, 13(9), 2733. https://doi.org/10.3390/pr13092733
Vancouver
Menargues S, Navas J, Espinosa I, Baile MT, Vaz RF, Picas JA. Effect of Additive Manufacturing Parameters on PLA, ABS, and PETG Strength. Processes. 2025;13(9):2733. doi:10.3390/pr13092733
BibTeX
@article{Menargues2025,
author = {Menargues, Sergi and Navas, Javier and Espinosa, Isabel and Baile, Maria Teresa and Vaz, Rodolpho Fernando and Picas, Josep Anton},
title = {Effect of Additive Manufacturing Parameters on PLA, ABS, and PETG Strength},
journal = {Processes},
year = {2025},
volume = {13},
number = {9},
pages = {2733},
doi = {10.3390/pr13092733}
}
EUVIMED