EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Multiparametric Optimization of Fabrication of Electrospun PVA Nanofibers for Utilization as Wound Dressing Mats

Tshepang Mqatywa iD, Mehrab Mahdian iD, Paula Ossowicz-Rupniewska iD, Karolina Zyburtowicz-Ćwiartka iD, Karolina Bilska, Anna Nowak iD, Tímea Beskid, Mária Laki, András József Laki, János Juhász iD, Tamás Pardy iD, Franciska Erdő iD

Polymers · 20.08.2026 · 18 (16) · 2018

DOI: 10.3390/polym18162018 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 20.08.2026. Verfasst von Tshepang Mqatywa und 11 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Information Technology and Bionics, Pázmány Péter Catholic University, Práter utca 50A, H-1083 Budapest, Hungary. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: International Visegrad Fund, Visegrad Fund, Ministry of Foreign Affairs of the Republic of Korea.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Electrospun poly (vinyl alcohol) (PVA) nanofibers are promising materials for wound dressings because of their high porosity, large surface area, and structural similarity to the extracellular matrix. In this study, a Box–Behnken design was used to optimize the effects of applied voltage, flow rate, spinning distance, and needle gauge on the fabrication of electrospun PVA nanofiber mats using an 8% (w/v) PVA precursor solution. Fiber morphology, diameter, porosity, thickness, swelling capacity, and thermal properties were evaluated. Stable electrospinning conditions produced uniform, bead-free nanofibers with mean diameters ranging from 198.9 ± 3.6 to 228.7 ± 1.5 nm. Needle gauge and flow rate were identified as the most influential parameters affecting fiber diameter, while voltage and spinning distance showed interaction-dependent effects. Thinner fibers generated using finer needles resulted in higher porosity and enhanced swelling behavior, whereas larger needle diameters produced thicker and denser mats. Thermal analysis demonstrated good thermal stability, with degradation onset temperatures ranging from approximately 225 to 280 °C, and melting transitions consistently occurring at 190–193 °C. The results establish clear process–structure–property relationships and demonstrate that multiparametric optimization enables reproducible fabrication of PVA nanofibers with tunable characteristics relevant for wound-dressing applications.

Schlagwörter

Stichwörter der Autor:innen

DSCPVA polymerTGAelectrospinningmanufacturing parametersnanofibersscanning electron microscopyswellingwound dressingswound healing

Autor:innen und Institutionen

  • Faculty of Information Technology and Bionics, Pázmány Péter Catholic University, Práter utca 50A, H-1083 Budapest, Hungary.
  • Thomas Johann Seebeck Department of Electronics, Tallinn University of Technology, 19086 Tallinn, Estonia.
  • Department of Chemical Organic Technology and Polymeric Materials, Faculty of Chemical Technology and Engineering, West Pomeranian University of Technology in Szczecin, Piastów Ave. 42, 71-065 Szczecin, Poland.
  • Faculty of Health Sciences, Pomeranian Medical University in Szczecin, 70-204 Szczecin, Poland.
  • Institute of Medical Microbiology, Semmelweis University, H-1089 Budapest, Hungary.
  • Department of Chemistry and Biotechnology, Tallinn University of Technology, 19086 Tallinn, Estonia.

ORCID-Profile: Tshepang Mqatywa, Mehrab Mahdian, Paula Ossowicz-Rupniewska, Karolina Zyburtowicz-Ćwiartka, Anna Nowak, János Juhász, Tamás Pardy, Franciska Erdő

Förderung

  • International Visegrad Fund
  • Visegrad Fund
  • Ministry of Foreign Affairs of the Republic of Korea

Zitieren

APA

Mqatywa, T., Mahdian, M., Ossowicz-Rupniewska, P., Zyburtowicz-Ćwiartka, K., Bilska, K., Nowak, A., Beskid, T., Laki, M., Laki, A. J., Juhász, J., Pardy, T., & Erdő, F. (2026). Multiparametric Optimization of Fabrication of Electrospun PVA Nanofibers for Utilization as Wound Dressing Mats. Polymers, 18(16), 2018. https://doi.org/10.3390/polym18162018

Vancouver

Mqatywa T, Mahdian M, Ossowicz-Rupniewska P, Zyburtowicz-Ćwiartka K, Bilska K, Nowak A, et al. Multiparametric Optimization of Fabrication of Electrospun PVA Nanofibers for Utilization as Wound Dressing Mats. Polymers. 2026;18(16):2018. doi:10.3390/polym18162018

BibTeX
@article{Mqatywa2026,
  author = {Mqatywa, Tshepang and Mahdian, Mehrab and Ossowicz-Rupniewska, Paula and Zyburtowicz-Ćwiartka, Karolina and Bilska, Karolina and Nowak, Anna and Beskid, Tímea and Laki, Mária and Laki, András József and Juhász, János and Pardy, Tamás and Erdő, Franciska},
  title = {Multiparametric Optimization of Fabrication of Electrospun PVA Nanofibers for Utilization as Wound Dressing Mats},
  journal = {Polymers},
  year = {2026},
  volume = {18},
  number = {16},
  pages = {2018},
  doi = {10.3390/polym18162018}
}
Kostenlos starten →