EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Engineering High-Performance Asphalt Binders and Mixtures Through Micro- and Nanocoke/Polymer Hybrid Modification

Yerdos Ongarbayev iD, Muhammad Hashami iD, Yerbol Tileuberdi iD, Yerzhan Imanbayev iD, Ainur Zhambolova iD, Yernar Kanzharkan iD, Aliya Kenzhegaliyeva, Aksaule Kydyrali, Dinmukhamed Abdikhan iD, Talgar Serik iD

Polymers · 16.08.2026 · 18 (16) · 1994

DOI: 10.3390/polym18161994 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymers, online erschienen am 16.08.2026. Verfasst von Yerdos Ongarbayev und 9 weiteren Autor:innen. Beteiligte Einrichtung: Faculty of Chemistry and Chemical Technology, Farabi University, 71, Al-Farabi Ave., Almaty 050040, Kazakhstan. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 54 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Science Committee of the Ministry of Science and Higher Education of the Republic of Kazakhstan.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Polymer modifiers and carbon-based materials have been widely proposed as potential asphalt additives to improve performance. However, limited studies have systematically compared micro- and nanocoke from different sources in combination with SBS and Elvaloy polymers or linked binder rheology with mixture performance. To address this gap, this study investigated the effects of micro- and nanodispersed petroleum and coal coke combined with SBS and Elvaloy polymers on the rheological behavior of asphalt binders and the performance of asphalt concrete mixtures. Rheological properties were evaluated by dynamic shear rheometer (DSR) testing, and asphalt concrete mixtures were tested for compressive strength and crack resistance. The modified systems were successfully used to obtain commercial polymer-modified bitumen grades: BMP 70/100, BMP 50/70 and BMP 35/50. With 1 wt.% micro coal coke and 0.1 wt.% SBS modification, a softening point of 73.7 °C and a penetration of 22.3 × 0.1 mm was observed. Micro coal coke–SBS system showed the highest compressive strength at 20 °C (3.29 MPa), while the largest crack resistance (4.39 MPa) and the best high-temperature mixture strength (0.90 MPa at 50 °C) were obtained when 0.5 wt.% nanocoke and 0.5 wt.% Elvaloy are used. These findings demonstrate that hybrid coke/polymer modification is an effective approach for enhancing asphalt performance, with micro coal coke–SBS systems providing the highest stiffness and rutting resistance, while nanocoke–Elvaloy systems delivered superior crack resistance and overall performance balance.

Schlagwörter

Stichwörter der Autor:innen

dynamic shear rheometerhybrid nanocomposite modifiersnanocokepavement performancepolymer-modified bitumen

Autor:innen und Institutionen

  • Faculty of Chemistry and Chemical Technology, Farabi University, 71, Al-Farabi Ave., Almaty 050040, Kazakhstan.
  • Institute of Combustion Problems, 172, Bogenbai Batyr Str., Almaty 050012, Kazakhstan.
  • Department of Chemistry, Faculty of Education, Mirwais Khan Nika Zabul University, Qalat 4001, Afghanistan.
  • Faculty of Natural Science and Geography, Abay Kazakh National Pedagogical University, 13, Dostyk Ave., Almaty 050010, Kazakhstan.

ORCID-Profile: Yerdos Ongarbayev, Muhammad Hashami, Yerbol Tileuberdi, Yerzhan Imanbayev, Ainur Zhambolova, Yernar Kanzharkan, Dinmukhamed Abdikhan, Talgar Serik

Förderung

  • Science Committee of the Ministry of Science and Higher Education of the Republic of Kazakhstan

Zitieren

APA

Ongarbayev, Y., Hashami, M., Tileuberdi, Y., Imanbayev, Y., Zhambolova, A., Kanzharkan, Y., Kenzhegaliyeva, A., Kydyrali, A., Abdikhan, D., & Serik, T. (2026). Engineering High-Performance Asphalt Binders and Mixtures Through Micro- and Nanocoke/Polymer Hybrid Modification. Polymers, 18(16), 1994. https://doi.org/10.3390/polym18161994

Vancouver

Ongarbayev Y, Hashami M, Tileuberdi Y, Imanbayev Y, Zhambolova A, Kanzharkan Y, et al. Engineering High-Performance Asphalt Binders and Mixtures Through Micro- and Nanocoke/Polymer Hybrid Modification. Polymers. 2026;18(16):1994. doi:10.3390/polym18161994

BibTeX
@article{Ongarbayev2026,
  author = {Ongarbayev, Yerdos and Hashami, Muhammad and Tileuberdi, Yerbol and Imanbayev, Yerzhan and Zhambolova, Ainur and Kanzharkan, Yernar and Kenzhegaliyeva, Aliya and Kydyrali, Aksaule and Abdikhan, Dinmukhamed and Serik, Talgar},
  title = {Engineering High-Performance Asphalt Binders and Mixtures Through Micro- and Nanocoke/Polymer Hybrid Modification},
  journal = {Polymers},
  year = {2026},
  volume = {18},
  number = {16},
  pages = {1994},
  doi = {10.3390/polym18161994}
}
Kostenlos starten →